TomTom LINK 300 Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk GPS TomTom LINK 300. TomTom LINK 300 46 halaman. Logbook
Juga untuk TomTom LINK 300: Manual (5 halaman)

Halaman Cetak

Borna_Logbook.book Page 4 Thursday, January 21, 2010 9:53 AM

Preparing your Remote LINK

Remote LINK starts searching for your LINK 300/310 and

the Connection LED begins to flash rapidly. Searching may

take about one minute before a connection is established.

Note: To check if a connection has been established press any

key. If a connection has been established, the Connection LED

will be on. If you do not use your Remote LINK for more than

10 seconds it will turn off.

If no connection was established the LED will switch off.

To establish a connection, repeat steps 1 to 4 or visit

www.tomtomwork.com/connect-remotelink for alternative

connection methods.

Reset your Remote LINK

If your Remote LINK is already paired but does not work

correctly or it is paired with the wrong device, you can reset

the Remote LINK to the default factory settings.

1. Press any key to switch on the device.

2. Press any two buttons at the same time until you hear a

sound.

Your Remote LINK switches off. To pair the device with the

LINK 300/310, read and follow the instructions under

'Establishing a paired connection'.