Epson R300 - Stylus Photo Color Inkjet Printer Panduan Instruksional - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instruksional untuk Aksesori Printer Epson R300 - Stylus Photo Color Inkjet Printer. Epson R300 - Stylus Photo Color Inkjet Printer 4 halaman. Product information guide
Juga untuk Epson R300 - Stylus Photo Color Inkjet Printer: Brosur (2 halaman), Lembar Informasi Produk (4 halaman), Manual (12 halaman), Panduan Pengguna (13 halaman), Referensi Cepat (4 halaman), Referensi Cepat (6 halaman), Brosur (2 halaman), Panduan Pengguna (12 halaman), Buletin Dukungan Produk (6 halaman), Buletin Dukungan Produk (1 halaman), Brosur (2 halaman), Panduan Petunjuk Instalasi (12 halaman)

b. Make sure the tubes are not twisted and are straight completely straight.

c. For regular printer model :

*** Adjust tubing between cartridge compartment and T shaped adhesive pad to correct the length; allowing

enough room for the cartridge to move back and forth freely (Fig. 4-3).

*** Place the second adhesive pad on the right side of the printer and adjust the tubing line accordingly.

Fig. 4-1

All in one models

*** The tubing line adjusts as shown (Fig. 4-4 ), allowing enough room for the cartridge to move back and forth freely.

Fig. 4-4

d. Close the cover and turn on the printer and make sure the system moves smoothly.

5. Refilling Ink

When the ink levels reach the indicator (sticker on the ink tank with red line Fig. 5-1) the ink tank has reached its low

level line and needs to be refilled.

Follow these steps:

1. Gently remove the air breather plugs in order to have more filling room.

2. Remove the rubber plug from the filling hole and refill the proper color of ink into the corresponding ink tank

(Fig 5-2).

3. Make sure you use the specially designed Low Foam inks for the CI System as they are specifically designed for

optimal results.

NOTE: When removing the CI System, remove cartridges and put tape or a napkin over dispensing hole.

Printer and ink tank MUST remain at the same level (not higher and not lower).

Fig. 5-1

Fig. 4-2

Fig. 5-2

Fig. 4-3