Argos Challenge Buku Petunjuk - Halaman 4
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kipas angin Argos Challenge. Argos Challenge 8 halaman. 16 inch pedestal fan
Halaman Cetak
BEFORE ASSEMBLING UNIT:
•Read these instructions carefully and familiarise your self with the procedure before assembling the unit.
•Check that you have all the component parts following the content list and familiarise yourself with each part before proceeding.
•Ensure you have enough space to lay out all the parts before assembly.
•Take all the parts out of the plastic bag and separate them into their groups.
•To avoid scratching it is recommended that you assemble the fan light on a soft level surface.
ASSEMBLY
• Loosen and remove the four bolts (18) from the two bars of the base (22 & 23). Cross the two bars as shown in fig. A.
•Position the flange (21) on to the base and align the holes.
•Secure the flange to the base with the four bolts.
•Remove the collar (16) from the stand pipe (20) by turning it counter -clockwise.
•Slide the base cap (17) down over the assembly and replace the collar (16).
• Loosen the set screw (14) by turning counter-clockwise with screw driver.
•Slide the fan housing support (13) down over the inner piper (15) until it contacts the inner stopper, aligning the groove in the
upper end of the inner pipe with the set screw.
•Tighten the set screw (14) by turning clockwise with screw driver. Unscrew the blade cap (3) from the motor shaft (9) .Please
note: unscrew clockwise.
•Remove the transparent plastic tube from the motor shaft (9).
• Unscrew the grille nut (5) from the shaft end of the motor until by turning the grille nut counter-clockwise.
•Mount the rear grille (7) on to the motor until by matching the holes on the rear grille to the pins on the front of the motor unit.
Push in firmly until the pins protrude through the holes.
•Secure the rear grille (7) to the motor unit with the grille nut (5).
• Insert the fan blade (4) onto the motor shaft so that the flattened side of the central hold corresponds with the flattened side of
the shaft. Press firmly until the fan blade stops.
•Secure the fan blade with the blade cap (3), turning counter-clockwise to tighten. Hold the fan blade while doing so.
•Test fan blade operation by rotating it with your hand. There should be no friction with the grille nut (5).If the blade does not
rotate freely, disassemble and repeat the procedure
•Remove the packing from the front grille (1)
•Open the four clips (2) by moving the lip of the clip outwards.
•Unscrew the locking screw(10) mounted on the rear grille(7). Mount front grille(1) onto rear grille(7) with the small round holes
on the top matched for the passage of locking screw. Fix both grilles with clips and then use screwdriver to tighten the locking
screw(10).
•Secure the two grilles by moving the lip inwards.