Dillenger Outlaw Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Skuter Dillenger Outlaw. Dillenger Outlaw 5 halaman.

Before the first use, please fully charge the battery, this can take up to 6 hours. The

smart charger will turn off the charging current once the battery is full and will NOT

overcharge the battery. Also ensure the tyre pressures are correct, check that all the

nuts and bolts on the bike are secure.

Front Wheel

Before the front wheel can be installed the spindle must be installed. Undo the knob

and remove the first spring. Slide the spindle through the hub, put the spring back

(narrow section pointing towards the wheel, wide section away) and put the screw

the knob back onto the spindle a few turns. DO NOT TIGHTEN THE KNOB ALL THE

WAY YET.

Once the spindle is installed in the wheel, the wheel can be installed into the bike.

Lift the front of the bike and slide in the wheel. With everything lined up, the weight

of the bike can be rested on the front wheel. Open the quick release lever and

tighten the knob to the point where closing the quick release lever offers a

reasonable amount of resistance. If the quick release cannot be closed, try undoing

the knob a quarter of a turn. If the lever is easy to close try tightening the knob a

little.

Once you have installed the front wheel lift the front of the bike off the ground and

spin the wheel. It should spin freely and should be straight when viewed from the

front. If the wheel drops out or is not straight reread the instructions and repeat the

previous steps.

Handlebars

The handlebars will arrive with the brakes and gears connected but will not be

attached to the frame. The bracket on the front of the handlebar stem needs to

removed and reattached with the handlebars in place. This will require a 5mm allen

key. Do the allen bolts up in a criss-cross pattern and be careful not to over tighten

them.

Pedals

Attach the pedals before riding. Each pedal will only fit on its respective side; they

are marked for easy installation either with a sticker on the pedal or embossed on

the end of the threaded section. A 15mm spanner is needed for this. The thread

direction is different for each pedal so the direction that tightens the pedals is

different for each side. The right-hand pedal is done up by tightening clock-wise and

the left is anti-clockwise.

Turning On/Off

Once ready, press and hold the on/off button and the display will turn on. The bike is

now on. Hold on/off again to turn the bike off.