Epson Stylus Pro 7900 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Printer Epson Stylus Pro 7900. Epson Stylus Pro 7900 12 halaman. With fully featured rip software by efi
Juga untuk Epson Stylus Pro 7900: Panduan Pengguna (28 halaman), Panduan Referensi Cepat (14 halaman), Laporan Pengguna (10 halaman), Manual Jaringan (43 halaman), Panduan Pemesanan (2 halaman), Manual Pembongkaran dan Pengaturan (30 halaman), Garansi Terbatas (12 halaman), Brosur (4 halaman), Panduan Petunjuk Instalasi (8 halaman), Manual Pembongkaran dan Pengaturan (28 halaman), Panduan Referensi Cepat (8 halaman), Panduan Referensi (32 halaman), Brosur & Spesifikasi (8 halaman), Informasi Produk (18 halaman), Setup Manual (30 halaman), Manual Pembongkaran dan Pengaturan (30 halaman), Panduan Referensi Cepat (12 halaman)

| Loading a Plate in the Printer

Press the

Paper release (ePlaten) button to disengage the feeder rollers.

Set the printer to the highest paper suction setting. This will help load the plate. To do that, press u to

increase the suction.

Lower the plate (with light gray, coated side face up) into the paper slot (short edge first) so at least

1 to 2 inches of the top edge are above the large plate guide. For example, the top edge of a 19-inch long

plate should be no less than 2 to 3 inches above the plate guide.

Slide the plate against the two alignment points along the top and bottom of the large plate guide. Make

sure that the plate touches both top and bottom alignment points.

While gently holding the plate against the guide, press the

engage the paper feeder rollers.

The

PRESS PAUSE

the paper release has closed.

WARNING:

The plate edges are sharp. To avoid injury, remove your hand from the plate after you press the

Pause/reset button.

message appears on the printer's LCD screen when the printer detects the plate and

Paper release

(ePlaten) button

Top alignment

point

Bottom

alignment point

Paper release (ePlaten) button again to