Acuity Controls ECLYPSE A1000 Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengontrol Acuity Controls ECLYPSE A1000. Acuity Controls ECLYPSE A1000 10 halaman. Asset tracking
Juga untuk Acuity Controls ECLYPSE A1000: Panduan Instalasi (14 halaman)

Halaman Cetak

Acuity Controls ECLYPSE A1000 Panduan Instalasi

1. Power Supply Information

1.0 - Introduction

1.1 Product Description

This document describes the installation procedures for

the ECLYPSE A1000AT. The ECLYPSE A1000AT

manages and controls a network of asset tags as part of

the Atrius Assets Solution. This programmable device

provides advanced functionality to process messages

from the asset tags and deliver them to the Atrius cloud.

For more detailed information about the ECLYPSE

A1000AT and its capabilities please refer to the

ECLYPSE A1000AT User Guide.

1.2 General Installation Requirements

For proper installation and subsequent operation of the

ECLYPSE A1000AT, pay special attention to the follo-

wing recommendations:

•

Upon unpacking the product, inspect the contents

of the carton for shipping damages. Do not install

damaged modules.

•

Avoid areas where corroding, deteriorating or explo-

sive vapors, fumes or gases may be present.

•

Ensure the mounting surface can support the cont-

roller, DIN rail, and optional enclosure.

•

Allow for proper clearance around the controller's

enclosure and wiring terminals to provide easy

access for hardware configuration and maintenance,

and to ventilate heat generated by the controller.

•

The controller's mounting orientation must be

horizontal with the controller's back attached to a

vertical wall surface. Orient the controller with the

ventilation slots and power supply input terminal

block connectors towards the top to permit proper

heat dissipation. When installed in a 3rd party enclo-

sure, select one that provides sufficient surface area

to dissipate the heat generated by the controller

and by any other devices installed in the enclosure.

A metal enclosure is preferred. If necessary, provide

active cooling for the enclosure.

•

The controller's datasheet specifies the power

consumption (amount of heat generated), the

operating temperature range, and other environ-

mental conditions the controller is designed to

operate under.

•

Ensure that all equipment is installed according to

local, regional, and national regulations.

•

If the controller is used and/or installed in a manner

not specified by Acuity, the functionality and the

protection provided by the controller may be

impaired.

Any type of modification to any Acuity product will void the product's

warranty.

Take reasonable precautions to prevent electrostatic discharges to the

controller when installing, servicing or operating the controller.

Discharge accumulated static electricity by touching one's hand to a well-

grounded object before working with the controller.

1.3 Device Markings (Symbols)

Certain markings (symbols) can be found on the control-

ler and are defined as follows:

Symbol

CE marking: the device conforms to the requirements of applicable

EC directives.

Double Insulation marking: These controllers are built using double

insulation.

Products must be disposed of at the end of their useful life

according to local regulations.

Read the Hardware Installation Guide for more information.

For indoor use only.

UL marking: conforms to the requirements of the UL certification.

FCC marking: This device complies with FCC rules part 15, subpart

B, class B.

Warning Symbol: Significant information required. Refer to the

Hardware Installation Guide.

HIGH VOLTAGE Symbol: Direct contact will cause electrical shock or

burn.

Alternating Current

Direct Current

Line

Neutral

Description

A1000AT_IG_10_EN

3 of 10