Motorola BACKFLIP Panduan Memulai Cepat - Halaman 33

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Ponsel Motorola BACKFLIP. Motorola BACKFLIP 34 halaman. Motoblur insert
Juga untuk Motorola BACKFLIP: Panduan Memulai (2 halaman), Manual Informasi Keselamatan (29 halaman), Petunjuk Peningkatan Perangkat Lunak (3 halaman), Manual Informasi Keselamatan (33 halaman), Panduan Memulai Cepat (1 halaman)

Safety, Regulatory & Legal

Specific Absorption Rate (IEEE)

SAR (IEEE)

Your model wireless phone meets the governmental

requirements for exposure to radio waves.

Your mobile device is a radio transmitter and receiver. It is designed

and manufactured to not exceed limits for exposure to radio frequency

(RF) energy set by the Federal Communications Commission (FCC) of

the U.S. Government and by the Canadian regulatory authorities. These

limits are part of comprehensive guidelines and establish permitted

levels of RF energy for the general population. The guidelines are

based on standards that were developed by independent scientific

organizations through periodic and thorough evaluation of scientific

studies. The standards include a substantial safety margin designed for

the safety of all persons, regardless of age or health, and to account

for any variations in measurements.

The exposure standard for mobile devices employs a unit of

measurement known as the Specific Absorption Rate (SAR). The IEEE

SAR limit set by the FCC and by the Canadian regulatory authorities is

1.6 watts per kilogram (W/kg), averaged over one gram of tissue. Tests

for SAR are conducted using procedures accepted by the FCC and by

Industry Canada with the mobile device transmitting at its highest

certified power level in all tested frequencies. Although the SAR is

determined at the highest certified power level, the actual SAR level of

the mobile device while operating can be below the maximum value.

This is because the mobile device is designed to operate at multiple

power levels so as to use only the power required to reach the

network. In general, the closer you are to a wireless base station, the

lower the power output.

Before a mobile device is available for sale to the public in the U.S. and

Canada, it must be tested and certified to the FCC and Industry Canada

that it does not exceed the limit established by each government for

safe exposure. The tests are performed in positions and locations (e.g.,

at the ear and worn on the body) submitted to the FCC and available

for review by Industry Canada. The highest SAR value for this mobile

device when tested for use at the ear is 1.37 W/kg, and when worn on

the body, as described in this guide, is 0.72 W/kg. The SAR value for

this mobile device in its data transmission mode (body-worn use) is