Epson TM-L90 series Panduan Pengembangan - Halaman 21

Jelajahi secara online atau unduh pdf Panduan Pengembangan untuk Aksesori Printer Epson TM-L90 series. Epson TM-L90 series 34 halaman. Attaching cover on the power switch
Juga untuk Epson TM-L90 series: Brosur (1 halaman), Brosur (2 halaman), Panduan Produk (27 halaman), Spesifikasi (2 halaman), Spesifikasi (8 halaman), Manual Informasi (5 halaman), Spesifikasi (4 halaman), Panduan Pengguna (40 halaman), Panduan Pengguna (17 halaman), Panduan Pengguna (21 halaman), Panduan Pengguna (21 halaman), Panduan Manufaktur (22 halaman), Mulai di sini (2 halaman), Mulai di sini (2 halaman), Manual (13 halaman), Petunjuk Manual (12 halaman), Panduan Pengguna (36 halaman), Manual (2 halaman)

3.5 MAXI CODE Printing

When printing MAXI CODE, set the Symbology parameter to one of the following

values.

PTR_BCS_MAXICODE

PTR_BCS_OTHER + 0

PTR_BCS_OTHER + 1

PTR_BCS_OTHER + 2

Because the size of MAXI CODE is fixed, printing is done at a fixed size that is

unaffected by the Width and Height parameters. An error occurs only when the

Width and Height parameters fall below zero. If the two dimensional barcode

cannot fit into the print area (depending on the paper width, layout settings, etc.)

then OPOS_E_ILLEGAL is returned and at this moment ResultCodeExtended

becomes zero.

Like the one dimensional barcode, the print position of the two dimensional

barcode is the specified position.

3.5.4.1 Mode 2

In the case of mode 2, because the format of header + primary message +

secondary message is fixed, data for the Data parameter must follow this format.

The header part contains the following data, which can be omitted.

"[)> RS 01 GS yy" (In hexadecimal: 0x5B 0x29 0x3E 0x1E 0x30 0x31 0x1D 0x..

0x..)

yy is '0' to '9' (0x30 to 0x39)

: Print using MAXI mode 2.

: Print using MAXI mode 3.

: Print using MAXI mode 4 or 5. The mode is set to

4 or 5 automatically depending on the length of the

Data parameter. (If the data is long, then the data

correction level is lowered for printing.)

: Print using MAXI mode 6.

APPLICATION DEVELOPMENT GUIDE

POSPrinter (TM-L90)

Version 3.00 Feb. 2019