Epson ActionTower 2000 Panduan Informasi Produk - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Informasi Produk untuk Desktop Epson ActionTower 2000. Epson ActionTower 2000 11 halaman. Multimedia sales kit
Juga untuk Epson ActionTower 2000: Baca Panduan Pertama Ini (29 halaman), Spesifikasi (4 halaman)

Halaman Cetak

Epson ActionTower 2000 Panduan Informasi Produk

EPSON ActionPC 1500/2000, ActionTower 2000

Tested Operating Environments

Although your system will run most software applications,

the following operating environments have been tested for

compatibility with your system.

Microsoft MS-DOS 3.1 and later

Novell DR DOS

Novell NetWare* 2.2,3.12, and 4.01

Novell NetWare Lite

IBM OS/2

SCO UN-IX

SCO Open Desktop

Microsoft Windows 3.0 and later

Microsoft Windows for WorkGroups

Microsoft Windows NT

*Certified as workstation

Your system has also been Novell tested and approved.

new environments become available, these also will be tested.

Installation/Support Tips

Installing Diskette Drives

in the SETUP program.

diskette drive controller.

Installing Hard Disk Drives

If you are installing a drive that cannot use the embedded

IDE interface, such as an ESDI hard disk drive, it is

recommended that you use a 16-bit, AT-type hard disk

controller. If you install a non-IDE hard disk drive and

controller card, you must set jumpers J14 and J16 to

position 2-3 to disable the built-in IDE hard disk drive

interface. Also be sure to remove the hard disk drive

ribbon connector from the system board.

When installing a hard disk drive, see the hard disk drive

type tables on pages 6 and 7 and use the auto-sensing

feature in SETUP to select the correct type number for the

drive. If the auto-sensing feature does not produce a

match for the drive, you can define your own drive type

by selecting User

Def 1

entering the drive's exact parameters.

10 - EPSON ActionPC 1500/2000, ActionTower 2000 5/9/94

or User

as the type and

Def 2

Software Problems

try the installation at high speed. If this does not work

properly, select low speed by pressing Ctrl Alt - (using the

numeric keypad). Try loading the program at low speed

and then switching to high speed, if possible.

its copy-protection method, try loading it at high speed. If

this does not work, load it at low speed.

Installing Option Cards

Cl If you are installing a video adapter card that doesn't

support VGA, make sure you disable the built-in VGA by

removing jumpers J1 and J2.

COM Port Assignment

jumper J7 to position 2-3. If you want to assign COM2 as

COM4, you must set jumper J9 to position 2-3.

Information Reference List

Engineering

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.