Motorola CLP1040 Panduan Pengguna - Halaman 31
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Radio Dua Arah Motorola CLP1040. Motorola CLP1040 48 halaman.
Chapter 5
Radio Cloning
This feature allows you to clone radio settings from one radio to another.
5.1
Cloning Radio Settings
You can copy the radio settings from the source to another radio.
You can use one of the following unit chargers and cables for cloning:
•
CLP Series Single Unit Charger (SUC) kit part number HKPN4008_ and CLP Series Cloning Cable
kit part number HKKN4026_ (optional accessory).
•
Multi-Unit Charger (MUC) Kit Part Number HKPN4007_ (optional accessory)
A multi-channel radio can be cloned to a single channel radio but only the first channel is cloned. The
MUC does not have to be plugged in for cloning, but both radios require charged batteries.
NOTE: The enhanced CLP software also uses the LED to indicate pass or fail status during
cloning. Green LED during cloning indicates pass status and red LED during cloning indicates
fail status.
5.2
Cloning Radios using the Cloning Cable
Prerequisites: Cloning radios using Multi-Unit Charger (MUC) kit part number HKKN4026_ (optional
accessory)
•
A fully charged battery on each radio.
•
Two Single-Unit Charger (SUC) Kits.
•
Both radios are turned off.
•
Source radio: Radio to be cloned.
•
Target radio: Radio to which the configuration of the source radio is to be copied.
Figure 12: Cloning the Radio through a Single Unit Charger
Procedure:
1 Unplug any cables such as power supply or micro USB cables from the SUC.
68012000044-ED
Radio Cloning
31