Epson Equity 386SX/16 PLUS Panduan Informasi Produk - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Informasi Produk untuk Desktop Epson Equity 386SX/16 PLUS. Epson Equity 386SX/16 PLUS 6 halaman. Product support bulletin(s)
Juga untuk Epson Equity 386SX/16 PLUS: Buletin Dukungan Produk (4 halaman)

Halaman Cetak

EQUITY 386SX/16 PLUS

Mouse and Keyboard

When attaching the mouse and keyboard connectors, be

careful to attach them to the proper connectors. Although they

are physically identical, they are not interchangeable.

Installing Floppy Disk Drives

When installing a floppy disk drive as drive B, remember to

set the drive select jumper to the second position and attach

the pass-through connector on the floppy drive controller

cable to the drive, not to the end connector.

drive type has been correctly selected in SETUP. Also check

that any special drivers that may be necessary have been

installed correctly.

Installing Hard Disk Drives

It is recommended that a 16-bit AT-type hard disk controller

be used in the Equity 3%&X/16 PLUS if you are instailing a

drive that cannot make use of the internal hard disk controller.

Also remember to disable the onboard hard disk controller

If you are having difficulty in formatting the hard disk drive,

try starting over with the Format option in diagnostics.

Setup

When installing a hard disk drive, be sure to consult the drive

If there is no match for your drive, use the User Defined

Adding Memory Modules

The total amount of memory must be one of the following

fast-page mode and have an access speed of t3Ons or faster.

Software Problems

When installing a copy-protected software package on the

If this does not work properly, try switching to 8 MHz for

the installation. If you are sbli unable to load the program

16 MHz.

When running a software program that uses a key disk as its

copy-protection method, try loading it at 16 MHz If this does

not work, enable the Auto Speed option in SETUP.

Power-on Password

If you set a power-on password, make sure you do not forget

it. If you do, it wili be necessary to disable it by moving

jumper 12 on the main system board to the A position

366SX/16 PLUS-6

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.