Dimac J06 Panduan Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Peralatan Industri Dimac J06. Dimac J06 6 halaman.

❖Massage code
Contents display : 【 Feed Length (_Release Mode) 】, Code number : 【 Feed Angle SPM 】
Feed Angle   SPM
Feed Length
- - ] ]
-. -. . ] . ] .
J06
CC - -
C. C. -. -.
4. 4 . 4 . 4 . 4 . 4 .
ENG
444444
1. 0 . 1 . 0 . 1 . 0 .
STOP
101010
1. 1 . 1 . 1 . 1 . 1 .
EnD
7. 7 . 7 . 7 . 7 . 7 .
EnD_2
EnD
777777
EnD_2
661661
662662
I - F
663663
664664
O_run
666666
❖Caution display
This caution displays have a possibility which the feeder is reset. These displays are as the follows,
Reset : Blinking. Feed Angle SPM : C. Number
Number
Code
C.
40
C.
41
 10 -1
C.
 10 -2
C.
 50 -1
C.
 50 -2
C.
 50 -3
C.
Contents
Ins. Left, Direction Push
Ins.Right, Direction Pull
Model
number
Ins. Left, Direction Pull
Ins.Right, Direction Push
Emergency stop switch ON
Emergency stop switch OFF
Input stop signal during driving
press
Input stop signal release
Input stop signal
Work shortage sensor ON
Another work shortage sensor ON
Work shortage sensor release
Another work shortage sensor release
Interfere releasing
Input feed signal during feeding
Input feed signal during releasing
Input release signal during feeding
Overrun
State / Content
Open phase
Low voltage detection
Setting mistake of the motor
capacity
Motor connection anomaly
Malfunction of Rotation sensor
6
Method of reset
When turning on power only, the
control panel displays the program
After releasing the Emergency
stop switch, turn off the power.
Turn on Reset switch after input
stop signal release
Turn on Reset switch
Automatic reset
After setting a work pieces, turn
on "Reset" switch
Turning off "Sync Feed", the work
shortage sensor will disabled.
Turn on "Reset" switch
Turn on "Sync Feed" and "Sync
Release" after turn on "Reset"
switch
Note
Confirmation of the power supply
Checking the voltage
Initial setting mistake
Contact failure
Setting mistake
CS-0169