Epson Equity IIe Buletin Dukungan Produk - Halaman 10
Jelajahi secara online atau unduh pdf Buletin Dukungan Produk untuk Desktop Epson Equity IIe. Epson Equity IIe 19 halaman. Product support bulletin(s)
Juga untuk Epson Equity IIe: Buletin Dukungan Produk (19 halaman), Panduan Informasi Produk (8 halaman), Buletin Dukungan Produk (45 halaman)
Q15. What VGA adapters are compatible with the Equity Ile?
A.
The following VGA adapters have been tested in the EQ Ile:
Epson VGA Plus 16 card.
Paradise VGA Plus 16 Card
Paradise VGA Professional Card
Video Seven Fastwrite Card
HARD DRIVES:
Q16.
What type of hard disk drives are available for the Equity Ile?
A.
The Equity Ile is available in one hard disk configuration using a 40Mb
3.5" hard disk, (Conner CP - 344, 29ms access time). This hard disk
drive offers a 1:1 interleave, using an embedded controller with an AT -
interface with Drive Type 59.
Q10.
What extended hard drive support is available in the ROM BIOS that
comes with the Epson Equity Ile?
A.
The Seiko - Epson BIOS will directly support hard drives that range in
size from 10Mb to 304Mb. There is direct support for the Seagate ST -
251 and the ST- 4096 hard disks, as well as, several ESDI drives. By
providing this support for 3rd party hard disk drives, the Equity Ile has
the capability to use most 3rd party 8- bit and 16 - bit hard disk
controllers. SCSI drives have their own controllers attached to the drive
and should work correctly when attached to the bus with a host
adapter.
There is a provision for setting up hard disk drives that are not
supported by the Equity Ile Drive Type Table.
In SETUP, a sub- menu lists the settings you can change for each
drive: the number of cylinders (tracks), the number of read/write heads,
the number of sectors, the precompensation cylinder, the landing zone
(the cylinder on which you want to park the heads when moving the
computer), and the total storage capacity in megabytes.
Q11.
What hard drive controller is used in the EQ Ile?
A.
The EQ Ile uses a AT- interface type controller embedded in the hard
drive. This controller connects to a Task File Host interface (LYNX- HI
board) that is attached to the LYNX system board.
PSB No: S-0105
Page 4 of 7