Motorola C601I Panduan Pengguna - Halaman 22
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon Tanpa Kabel Motorola C601I. Motorola C601I 36 halaman. Digital cordless phone
Halaman Cetak
6.3
Change base PIN code
Some functions are protected by a 4 digit PIN code which
must be entered if you want to change the settings. The
default PIN is 0000. You can change this to your own
preferred number.
When you enter a PIN, the digits are shown as
m
d
1. Press
, scroll
to
d
PIN CODE
2. Scroll
to
and press
3. Enter the 4 digit PIN code (default = 0000) and press
m
.
4. Re-enter the new PIN again and press
IMPORTANT
If you change the PIN code, please keep a record of the new
number.
6.4
Tone/Pulse setting
Your phone is set to tone dialing. You should only need to
change this if connected to an older type of switchboard/PBX
which requires pulse dialing.
m
d
1. Press
, scroll
to
d
DIAL MODE
2. Scroll
to
and press
u
d
3. Press
or
to select
m
to confirm.
22
****
.
m
SETUP
and press
.
m
.
m
to confirm.
m
SETUP
and press
.
m
.
TONE DIAL
PULSE DIAL
or
and press
6.5
Flash setting
Depending on your country and network operator, your
phone has the flash time set as 600 ms (FLASH 2). It is
unlikely that you need to change this setting unless advised
to do so.
m
d
1. Press
, scroll
to
d
FLASH
2. Scroll
to
and press
u
d
3. Press
or
to select
FLASH 2
(long flash time) and press
Note
You may need to use the flash function if you are connected
to a PBX switch.
Contact your PABX supplier for further information.
6.6
Restore default settings
You can restore your phone to its default (original) settings.
All the handsets that are registered to the base will be
retained.
WARNING
Resetting your phone to its default settings will delete all
entries in the Phonebook and Calls list. All handset and base
settings will also be reset.
m
d
1. Press
, scroll
to
d
DEFAULT
2. Scroll
to
and press
m
SETUP
and press
.
m
.
FLASH 1
(short flash time) or
m
to confirm.
m
SETUP
and press
.
m
.
Base settings