Motorola GM600 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Radio Motorola GM600. Motorola GM600 11 halaman. Remote mount kit
Juga untuk Motorola GM600: Panduan Servis (28 halaman), Panduan Instalasi (10 halaman)

Halaman Cetak

Incoming Calls

There are two types of systems that the radio may

be used on, Off Air Call Set Up (OACSU) and Full

Off Air Call Set Up (FOACSU).

If you are in any doubt about which system you are

operating on, consult your network manager.

Receiving a call on an OACSU system -

When the radio is called tone D will sound and the

yellow LED ﬂashes. This will then be followed by

tone B.

Receiving a call on an FOACSU system -

When the radio is called tone E will sound and the

yellow LED ﬂashes. Press the PTT to accept the

call. Tone D will sound until a speech channel is

allocated, then tone B sounds.

Note:

The system may have a limited call time and the

call may be terminated automatically if this call

time is exceeded.

Call In Absence

Call in Absence only applies to radios if

preprogrammed, please consult your network

manager.

If programmed, when a call is not answered within a

set amount of time, the call is stored by the radio.

Group calls are ignored.

Up to 5 calls can be stored. If the same radio calls

more than once, the call is only stored once. When 5

calls have been stored by the radio the sixth call

received overwrites the ﬁrst.

Note:

The calls in the stack are deleted when the radio is

turned off. It is not possible to call back status calls.

Display Radios

When a call has been stored by the radio, tone G

sounds every ten seconds. The call in absence icon

will be lit to indicate there is a call in the stack.

To view/interrogate the calls in the stack press the

Select Button B and use the up/down scroll keys to

view numbers in the stack.

The most recent call stored by the radio is displayed

ﬁrst. Select the up/down scroll keys to display calls

in the stack. If the stack is empty tone H sounds.

To exit the call in absence interrogate mode press

Select Button B again.

Press the PTT button to make a call to the number

displayed. On a successful call set-up, the entry is

automatically deleted from the stack. Unanswered

calls may be deleted from the stack at any time by

pressing the Clear Button.

Incoming Calls

English