Motorola Radius CM200 Panduan Instalasi - Halaman 34

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Radio Motorola Radius CM200. Motorola Radius CM200 36 halaman. Commercial series

3. Ignition Switch

4. Lamp bulbs (headlamps, tail lamps, dome lamps, etc.)

5. Accessory wiring (electrical fuel pump, electric windshield wipers, heater fan motor, window

openers, etc.)

10.7

Ground Bonding

If a vehicle is not properly bonded to ground, static charges can increase. This increase can cause

noise from electrical arcing. This type of noise is suppressed by bonding the part using one-inch wide

ground straps (keep them as short as possible). Some common points where bonding may be helpful

are listed below (see Figure 10-5).

A. From engine block to the firewall.

B. From engine block to vehicle frame at points where the engine is shock-mounted.

C. From the battery ground terminal to the vehicle body.

D. From top of front wheel "A" frames to chassis, particularly in cases where rubber-mounted

members are used.

Firewall

Battery

Figure 10-5. Ground Bonding

Fender

Well

Chassis

Noise Reduction Techniques

Front Wheel

"A" Frame

FL0830266-O