Motorola T3 Panduan Pengguna - Halaman 28
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Radio Motorola T3. Motorola T3 50 halaman. User guide
Juga untuk Motorola T3: Panduan Memulai Cepat (2 halaman), Brosur (2 halaman), Manual (38 halaman)
Halaman Cetak
Managing the Wireless WallPlates
Public IP address
If you wish to use 802.1x authentication, or if you wish to use ping to monitor the Wireless WallPlates, you must
set the DHCP pool as a public pool. Note the following steps are required:
Disable the private IP gateway address:
Configure the public IP network:
For example:
NOTE: The public pool must be in the same subnet as the IP address of the T3 Switch.
Static IP address pool
Static leases can be added for the public IP address pool. To use a static lease, you must know the MAC
address of the radio and the IP you wish to assign. To get a list of MAC addresses, first link the Wireless
WallPlates via the standard DHCP server configuration. View the list using, "show dhcp server lease". The list
of MAC addresses can be used to create the static lease table.
The MAC address of the radio is printed on the product serial label. Also, the MAC addresses will appear in the
forwarding bridge. To view the forwarding bridge table, type "show bridge address"
Disable the private IP gateway address:
Configure the static lease entry:
Motorola, Inc.
ip private disable
dhcp server disable
dhcp server config network public start <ip> end <ip>
dhcp server enable
ip private disable
ip config ip-address 10.1.1.2 mask 255.255.255.0 gate 10.1.1.1
dhcp server disable
dhcp server config network public start 10.1.1.101 end 10.1.1.125
dhcp server enable
ip private disable
dhcp server disable
dhcp server static-lease add <mac address> ip <ip>
dhcp server enable
570510-001-00 rev A
Page 28 of 50