Motorola Astro XTL 5000 Buku Petunjuk - Halaman 25
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Radio Portabel Motorola Astro XTL 5000. Motorola Astro XTL 5000 38 halaman. Dual-radio w3 handheld control head system
Halaman Cetak
Chapter 4 Troubleshooting
4.1
Power-Up Errors
In the event that there is a setup problem while powering up the system, the system attempts to
notify the user of this problem by displaying a power-up error messages (see
head displays power-up errors occurring in either radio.
If one of the radios is not connected at power-up, an error message is displayed, and the remaining
radio continues to function. If both radios are configured as Primary Radios or both radios are
configured as Auxiliary Radios, a fatal error is displayed and the system will not function. See
Chapter 3, "Codeplug Configuration"
Any power-up failure during the self-check routine will cause the associated radio to generate a Bad
Key Tone.
NOTE: In the event that there are errors with encryption on the Unselected Radio, they will not be
displayed on the control head at power-up. Instead, the error will be shown when that radio is
selected and the user presses PTT to transmit. All audible indications of the error will be heard
at power-up regardless of radio selection.
Table 4-1. XTL 5000 Dual-Radio Power-Up Self-Check Error Codes
Error Code
ERROR 21 or 01/02
ERROR 01/10
followed by 02/10
ERROR 21/10
followed by 22/10
ERROR 21 or 01/12
ERROR 21 or 01/22
FAIL 21 or 01/81
FAIL 21 or 01/82
FAIL 21 or 01/88
FAIL 21 or 01/90
FAIL 21 or 01/92
FAIL 21 or 01/93
FAIL 21 or 01/98
FAIL 21 or 01/A2
FAIL 22 or 02/81
FAIL 22 or 02/88
9964416H03-O
for details on codeplug configuration.
Description
Flash ROM Codeplug Checksum
Primary Radio Hardware Failure
Auxiliary Radio Hardware Failure
Security Partition Checksum
Tuning Codeplug Checksum
FLASH ROM Checksum
FLASH ROM Codeplug Checksum
External SRAM Failure
General Hardware
Security Partition Checksum
FLASHport AUTHENT CODE Failure
Internal RAM Failure
Tuning Codeplug Checksum
DSP ROM Checksum
DSP RAM Fatal Error
Error Type
Troubleshooting Chart
NON-FATAL
Reprogram the Codeplug.
NON-FATAL
Check the Primary Radio
connection.
NON-FATAL
Check the Auxiliary Radio
connection.
NON-FATAL
Reprogram the security partition.
FATAL
Reprogram the tuning partition.
FATAL
Reprogram the Radio.
FATAL
Reprogram the Codeplug.
FATAL
Turn the radio off, then on.
FATAL
Turn the radio off, then on.
FATAL
Reprogram the security partition.
FATAL
Contact the Depot.
FATAL
Turn the radio off, then on.
FATAL
Reprogram the tuning partition.
FATAL
Reprogram the DSP firmware.
FATAL
Turn the radio off, then on.
Table
4-1). The control
October 27, 2004