Epson LABELWORKS PX Panduan Operator - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pembuat label Epson LABELWORKS PX. Epson LABELWORKS PX 14 halaman.
Juga untuk Epson LABELWORKS PX: Panduan Pengguna (4 halaman)

Halaman Cetak

1. The Basics - How to

Safety Instructions

For your safety, read the attached documents carefully to use this product correctly. After you have read

all instructions, keep this manual handy for future reference and to make your concerns clear.

Items below indicate safety precautions to protect users, their surroundings and their property from

possible injury or damage.

Precautionary notations are categorized as follows according to personal injury and damage to the

equipment if the instructions are ignored or the equipment is misused.

DANGER

This symbol indicates information that, if ignored, could possibly result in serious or fatal

personal injury. Take extra caution in performing procedures with DANGER headings.

WARNING

This symbol indicates information that, if ignored, could possibly result in serious personal

injury or even death due to incorrect handling.

CAUTION

This symbol indicates information that, if ignored, could possibly result in personal injury or

physical damage due to incorrect handling.

The following describes the meaning of each symbol used in the precautions.

This indicates an important reminder.

This indicates a prohibited item.

This indicates a mandatory procedure.

DANGER

When handling batteries

If liquid leaking from an alkaline battery gets into your eyes, do not rub your eyes but

immediately wash them well with clean water and contact a doctor. Otherwise, it may cause

blindness.

WARNING

When using the AC adapter and power cable

The cords included with this product contain chemicals, including lead, known to the State

of California to cause birth defects or other reproductive harm. Wash hands after handling.

(This notice is provided in accordance with Proposition 65 in Cal. Health & Safety Code

§25249.5 and following.)

Do not use any AC adapter or power cable other than the dedicated AC adapter and power

cable. Do not use the AC adapter with other than the specified voltage also. Otherwise,

damage, overheating, fire or electric shock may occur.

Take the following precautions when handling the AC adapter and power cable.

• Make sure to avoid octopus wiring.

• Make sure the plug is not dusty before inserting it into an outlet.

• Insert the plug firmly into the outlet.

• Do not hold the plug with wet hands.

• Do not pull the power cable when disconnecting

the plug. Be sure to hold the plug when disconnecting it.

• Do not make any modification to the AC adapter or power cable.

• Do not apply strong shocks to or put a heavy object on the AC adapter or power cable.

• Do not bend or twist the AC adapter or power cable forcibly.

• Do not place the AC adapter or power cable near a heater.

• Do not use any damaged AC adapter or power cable.

• Do not touch the plug during thunderstorms.

• Do not unplug the AC adapter while the product is in operation.

• Do not use the AC adapter in a small, confined space, or cover it with a cloth.

When handling batteries

Keep batteries out of reach of children. They are extremely dangerous if swallowed. Contact a

doctor immediately if swallowed.

When using this product

Do not apply any strong force or shocks to the product such as standing on, dropping or

hitting it. Otherwise, the product may be broken, which may result in fire or electric shock.

If it is damaged, turn off the power immediately, unplug the AC adapter and remove the

batteries, and then contact the K-Sun customer support center. Continuous use may result in

fire or electric shock.

Take care not to spill any beverage such as tea, coffee or juice onto the product, or to spray

aerosol insecticide. It may cause malfunction, fire, or electric shock. If any liquid has been

spilled on the product, turn off the power, unplug the AC adapter and remove the batteries

immediately, and then contact the K-Sun customer support center. Continuous use may result

in fire or electric shock.

Do not touch the printhead because it becomes very hot. Otherwise, there is a risk of burns.

Do not open any covers other than the cover designated by this manual. Doing so may result

in fire or electric shock. Always use the product as instructed in this manual. Otherwise,

damage or injury may occur.

If any of the following abnormalities is observed, turn off the power immediately, unplug the

AC adapter and remove the batteries, and then contact the K-Sun customer support center.

• If smoke, strange odours or unexpected noises come from the product

• If liquid or foreign objects get inside the product

• If the product has been dropped or damaged

WARNING (cont.)

When handling the cutter

Do not touch the exit slot (where labels come out) during printing or when using the cutter,

otherwise there is a risk of injury.

Others

Do not use or store the product, batteries, AC adapter, power cable, or tape cartridges in the

following places.

• In direct sunlight.

• Where it may become extremely hot such as in a vehicle with the windows closed.

• Where it may become extremely hot such as near a heater or the temperature becomes very

unstable such as near the exhaust duct of an air conditioner.

• Where the product may get wet due to a shower or rain such as in a bathroom or outdoors.

• In a dusty place or where the product may be exposed to smoke or steam such as near the

kitchen or a humidifier.

• On an unstable place such as on a shaky table or on an inclined place.

• Where it might be subjected to vibration or shock.

• Near high-voltage power lines or something that generates a magnetic field.

Keep the plastic bags used to contain the product or this manual out of reach of children.

Children may suffocate if they swallow them or put their heads into the bags.

CAUTION

When handling batteries

If liquid leaks from a battery, wipe it off with a cloth and replace it with a new one. If the liquid

comes in contact with your skin, wash it away with water immediately.

If the batteries are used incorrectly, they may cause leakage, overheating, explosion, erosion,

or damage to the product, which may result in fire or injury.

• Do not use new ones and old batteries together, or mix different types of batteries.

• Use only AA Alkaline batteries. Rechargeable batteries cannot be used.

• Use batteries in the correct directions.

• Take the batteries out immediately when they have no power remaining.

• Take the batteries out if you do not use the product for a long time.

• Do not heat batteries or throw them in fire or water.

• Do not pinch the batteries with metal tweezers or use any pointed sharp metal object such

as the tip of a mechanical pen or ball-point pen when taking the batteries out.

When disposing of used batteries, make sure to follow the regulations.

When using this product

To ensure safety, unplug this product before leaving it unused.

Before cleaning, make sure to unplug the AC adapter from the outlet, and remove the

batteries.

When handling tape cartridges

• Make sure to use a dedicated

PX Tape.

• Some types of tape cannot be cut by the cutter. For the details, refer to the tape's manual.

• Do not drop it or disassemble it. Doing so may cause damage.

• Avoid using a tape cartridge without remaining tape. Doing so may cause overheating of the

printhead, which may result in damage or malfunction.

MEMO

Tape cartridges contain ink ribbons in them. When disposing tape cartridges, make sure to follow the

local regulations for disposal.

Other cautions

Notes on usage

• Take care not to cut your fingers when cutting the label with scissors.

• Do not attach a label on human bodies, living things, public facilities or other people's belongings.

About the printed labels

• Depending on the environment labels are used in and the nature of the object labels are attached to,

the following issues may occur:

Label: Discoloration, faded characters, peeling

Adhesive side: Adhesive residue, staining, damage

• Carefully check the suitability of the label for the intended purpose before use. K-Sun takes no

responsibility for any damage or loss due to the above mentioned causes.

About the Symbols on this Product

On this product, the following symbols are used in order to ensure safety and proper use of the

product, and to prevent danger to users and other persons as well as property damage.

The symbols indicate the meanings listed below. Be sure that you completely understand the meaning

of the symbols on this product before using it.

On/Stand-by

Direct current

Hot surface

Polarity of D.C. power connector