Epson OT-TB34 Panduan Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pembuat label Epson OT-TB34. Epson OT-TB34 2 halaman.

7. Slide the paper ejection guide to as wide a position as possible, and lock it.

Setting the Printer Driver

The following driver setting is required to cut GD wristbands at the perforation with the

tear bar, instead of cutting with the autocutter.

1. Select [No Auto Cut] and [Feed To Peel Off Position] in [Settings For Handling Media

After Print] in the [General] tab of the printer driver.

2. Disable the Cut button in [Panel Button Settings] in the [Maintenance And Utilities]

tab.

3. Click [OK] to complete the setting.

Installing GD Wristbands

1. Load the wrist band roll completely inside the printer with the printable side up

(black marks down).

2. Pass the wrist band through the tear bar.

3. Close the roll paper cover with care to keep the wrist band through the tear bar.

4. The wrist band is fed automatically when the roll paper cover is closed or the printer

is turned on.

For initial setting of the printer or details on making paper changes, see "Installing Paper"

in the TM-C3400 User's Manual.

Note:

Pulling the wrist band horizontally when cutting it may misalign it from its correct printing

position. Be sure to cut the wrist band while pulling it upward.

Cautions

Depending on the area, the interface cable may be included with the product. If so, use that cable.

Seiko Epson Corporation shall not be held liable for any damage resulting from electromagnetic

interference that occurs from the use of any interface cables other than those designated as Epson approved

products.

EPSON is a registered trademark of Seiko Epson Corporation in Japan and other countries/regions.

General Notice: Other product and company names used herein are for identification purposes only and

may be trademarks of their respective companies.