Epson 1280 - Stylus Photo Color Inkjet Printer Informasi Produk - Halaman 7

Jelajahi secara online atau unduh pdf Informasi Produk untuk Perangkat lunak Epson 1280 - Stylus Photo Color Inkjet Printer. Epson 1280 - Stylus Photo Color Inkjet Printer 13 halaman. Product support bulletin(s)
Juga untuk Epson 1280 - Stylus Photo Color Inkjet Printer: Penggantian Kartrid (2 halaman), Buletin Dukungan Produk (6 halaman), Buletin Dukungan Produk (1 halaman), Panduan Tambahan (1 halaman), Panduan Pengguna (27 halaman), Panduan Kompatibilitas (1 halaman), Panduan Tambahan (2 halaman), Mulai di sini (2 halaman), Brosur & Spesifikasi (2 halaman), Mulai dari Sini Manual (6 halaman), Spesifikasi (2 halaman), Panduan Pengguna (12 halaman), Buletin Dukungan Produk (3 halaman), Buletin Dukungan Produk (2 halaman), Buletin Dukungan Produk (4 halaman), Buletin Dukungan Produk (7 halaman), Panduan Memulai (32 halaman), Panduan Petunjuk Instalasi (8 halaman)

Halaman Cetak

Epson 1280 - Stylus Photo Color Inkjet Printer Informasi Produk

3. Lift up the two ink cartridge clamps.

4. Unwrap the ink cartridges, then remove only the yellow

part of the tape seal on top. Don't pull off the blue part.

Black ink

Color ink

cartridge

5. As you face the printer, tilt each cartridge forward (toward

you) slightly as you lower it into its holder. Position the tabs

at the back of the cartridge on top of the hooks on the

holder clamps.

tabs

hooks

Don't place the cartridges under the holder clamp; you

may damage the clamp when you close it.

6. Close the ink cartridge clamps. (You need to press the color

clamp a little more firmly.)

7. Press the ink cartridge replacement button (shown in step 2)

and close the printer cover.

Ink charging takes about two minutes, with the P power light

flashing and the printer making noise until it's finished. Don't

turn off the printer or interrupt charging or it will start over,

using more ink than necessary. It's finished when the P power

light stops flashing.

Testing the Printer

You can run a printer check to determine whether a problem

comes from the printer itself or some other source. Follow

these steps to run the printer check:

1. Make sure both the printer and computer are turned off.

2. Disconnect the interface cable from the printer.

3. Make sure letter-size or larger paper is loaded in the printer.

4. Hold down the b maintenance button, then press and

Don't touch the

release the Ppower button. Continue holding down the

green chips

b maintenance button until the Ppower light starts to

flash, then release it.

The printer prints one page showing its ROM version

number, ink counter, and a nozzle check pattern. Only the

nozzle check pattern is shown below. (If the pattern has

gaps in its dots, you need to clean the print head; see

page 10.)

5. To end the check, turn off the printer after it prints the

check page. Then reconnect the interface cable and turn on

your printer and computer.

If the check page prints, the problem probably lies in your

software settings, the interface cable, or your computer.

If the check page doesn't print, you may have a problem with

your printer.

Try the suggestions in "Problems and Solutions" in the Printer

Basics book.

1/01

EPSON Stylus Photo 1280

- 7