Epson 6110i - PowerLite XGA LCD Projector Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Epson 6110i - PowerLite XGA LCD Projector. Epson 6110i - PowerLite XGA LCD Projector 17 halaman. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Juga untuk Epson 6110i - PowerLite XGA LCD Projector: Panduan Pengguna (42 halaman), Panduan Pengoperasian (36 halaman), Panduan Pengoperasian (47 halaman), Spesifikasi (2 halaman), Panduan Tambahan (1 halaman), Panduan Pengaturan Cepat (7 halaman), Panduan Pengguna (1 halaman), Daftar Bagian (1 halaman), Pernyataan Kesesuaian (4 halaman), Buletin Dukungan Produk (25 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (41 halaman), Buletin Dukungan Produk (15 halaman), Buletin Dukungan Produk (22 halaman)

Epson PowerLite 6110i

Turning On the Projector

Make sure your projector and other equipment are set up and

connected correctly. Then turn on your projector, as described

below.

If you turn on your connected computer or video equipment

before starting the projector, the projector automatically

detects and displays the image source. If you turn on the

projector first, or have multiple pieces of equipment

connected, you may have to select the image source manually.

See "Adjusting the Image and Presentation" on page 6.

Follow these steps to plug in and turn on the projector:

1. Plug one end of the power cable into the projector, and the

other end into a grounded electrical outlet.

2. Wait until the P Power light stops flashing and turns

orange.

Power light

3. Press the orange P

or press the P

Power

(If this is your first time using the remote control, make sure

the batteries are installed.)

Note: If the Direct Power On feature has been enabled, you

don't need to press the P Power button to turn the projector on.

Just plug the projector into an electrical outlet. When the

P Power light stays green, the projector is ready to use.

Warning: Never look into the lens when the lamp is on. This can

damage your eyes, and is especially dangerous for children.

Power button

The P Power light flashes green as the projector warms up,

and an image begins to appear. When the P Power light

stops flashing and remains green (in about 20 seconds) the

projector is ready for use.

4. If you've connected a Windows-based computer to the

projector, you may see a New Hardware Wizard saying your

computer has found a plug-and-play monitor; if so, click

Cancel

12/07

button on top of the projector—

Power

button on the remote control.