Epson C11C605001 - DFX 9000 B/W Dot-matrix Printer Panduan Pengguna - Halaman 20
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Epson C11C605001 - DFX 9000 B/W Dot-matrix Printer. Epson C11C605001 - DFX 9000 B/W Dot-matrix Printer 28 halaman. User guide - remote configuration manager
Juga untuk Epson C11C605001 - DFX 9000 B/W Dot-matrix Printer: Spesifikasi (2 halaman), Memperbarui Firmware (1 halaman), Panduan Pengguna (15 halaman)
Halaman Cetak
9.
If you want to save the settings, select
button. If you don't want to save the settings, select
D (
) button. The printer exits SelecType mode.
Set
Top of Form
Note:
If you turn off the printer prior to exiting the SelecType mode, any changes you have
made are canceled and not saved.
Default-setting Mode
Use the Default-setting mode if you need to adjust the print head position for
printing on uneven forms or to choose which control panel buttons to lock
when Lock-out mode is turned on. (See page 21 for more information about
Lock-out mode.)
Continuous forms with labels
If you are printing on forms of varying thicknesses—for example, a form that
includes a label in addition to standard printing—you may need to adjust the
setting. By defining the position of the label, you tell the printer
Forms w/labels
where it needs to raise the print head to accommodate the greater thickness as it
prints over the label.
Before you can change the settings for continuous forms with labels, use
SelecType as described on page 19 to make sure the
to
.
On
20 Default-setting Mode
by pressing the
U (
Yes
Set
Tear Off
by pressing the
No
setting is set
Forms w/labels
)
Note:
You do not need to change these settings for printing label sheets of uniform thickness.
Setting
Label base position
Label top position
Label length
Label left position
Label width
Base sheet PG (platen gap)
position number
Label paper PG (platen gap) position
number
*
Adjusts the platen gap for printing on label carrier (base sheet).
** Adjusts the platen gap for printing on labels affixed to label carrier.
Lock-out mode settings
Button function
Pause
Micro Feed
Load
LF
FF
Top of Form
Tear Off
Font
Pitch
Front/Rear
Menu
Reset
Options (default in bold)
Paper left edge, First dot
0 to 4752/216 (0 to 22" in 1/216-inch increments)
0 to 4752/216 (0 to 22" in 1/216-inch increments)
0 to 1440/120 (0 to 12" in 1/120-inch increments)
0 to 1440/120 (0 to 12" in 1/120-inch increments)
0 to 14*
0 to 14**
Settings (default in bold)
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock
Unlock, Lock