Epson FX-1180 - Impact Printer Panduan Cepat - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Cepat untuk Perangkat lunak Epson FX-1180 - Impact Printer. Epson FX-1180 - Impact Printer 33 halaman. Epson serial impact dot matrix printers
Juga untuk Epson FX-1180 - Impact Printer: Setup Manual (33 halaman), Brosur & Spesifikasi (24 halaman), Informasi Produk (17 halaman), Panduan Referensi Cepat (16 halaman), Manual (11 halaman), Spesifikasi (2 halaman), Manual (18 halaman), Spesifikasi (2 halaman), Garansi Terbatas (1 halaman), Panduan Referensi (34 halaman)

7. Fit four holes of the paper over the

tractor pins on both sprockets. Then

close the sprocket covers.

8. Slide the right sprocket to remove any

slack in the paper, then lock it in place.

9. Open the edge guides on the paper guide

all the way to the left and right, then raise

the continuous paper support.

10. If you are using the front slot, open the

flap on the front cover. Then, reattach the

front cover as shown below.

11. Turn on the printer.

Downloaded from:

http://www.usersmanualguide.com/

EPSON FX-880+/FX-1180+ Quick Guide

12. Remove any slack in the paper by

pressing the LF/FF button.

Caution:

Always remove any slack from the

paper; otherwise print quality may

deteriorate.

13. When the printer receives data, it will

start printing at the current position

without advancing the paper. If

necessary, follow the steps in "Micro

Adjust Function" to adjust the current

position of the paper.

Caution:

Never use the knob to adjust the

top-of-form position; this may

damage the printer or cause it to lose

the top-of-form position.

14. Attach the printer cover by inserting the

front tabs into the slots on the printer,

then lowering the cover into place.

15. Send a print job to the printer. The

printer starts printing from the

top-of-form position. After you finish

printing, tear off the printed document

at the perforation nearest the paper exit

slot.

Continuous Paper with the Pull Tractor (3/4)