Epson LQ-2090 Panduan Pengguna - Halaman 36
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Epson LQ-2090. Epson LQ-2090 48 halaman. Epson lq-2090: product brochure
Juga untuk Epson LQ-2090: Manual (11 halaman), Referensi Cepat (12 halaman), Spesifikasi (2 halaman), Spesifikasi (2 halaman), Spesifikasi (4 halaman)
![Epson LQ-2090 Panduan Pengguna](/uploads/products/server2/619979/619979.png)
4
Tear Off/Bin
(Set) button
Tear Off/Bin
lights
5
Menu buttons
Menu lights
6
Load/Eject
button
7
Micro Adjust
8
LF/FF button
9
Pause button
10
Pause light
11
Paper Out light
36
Using the Control Panel
Feeds continuous paper forward to the tear-off position.
Feeds continuous paper backward from the
tear-off position to the top-of-form position.
Selects a cut-sheet feeder bin when it is installed.
In default setting mode, selects a value.
Both flash when continuous paper is in the tear-off
position.
Both off when continuous paper is not in the tear-off
position or when bin 1 of the optional cut-sheet feeder
is selected.
Left light is on when Card mode is selected.
Right light is on when bin 2 of the optional cut-sheet
feeder is selected.
When you press the Pitch (Item
buttons at the same time, the printer enters or exits
default setting mode. See "Changing the Printer's
Default Settings" on page 38.
When the printer is in default setting mode, both menu
lights are on.
Loads a single sheet of paper.
Ejects a single sheet of paper.
Loads continuous paper from the standby position.
Feeds continuous paper backward to the standby
position if a sheet is loaded.
When you hold down the Pause button for three
seconds, the printer enters Micro Adjust mode. In this
mode, you can press the LF/FF
buttons to adjust the top-of-form or tear-off position.
See "Using the Micro Adjust Function" on page 31.
Feeds paper line by line when pressed quickly.
Ejects a single sheet or advances continuous paper to
the next top-of-form position when held down.
Stops printing temporarily, and resumes printing when
pressed again.
When held down for three seconds, enters Micro Adjust
mode. When pressed again, exits Micro Adjust mode.
On when the printer is paused.
Flashes when the printer is in Micro Adjust mode.
On when no paper is loaded in the selected paper
source or paper is not loaded correctly.
Flashes when paper has not been fully ejected or paper
is jammed.
) and Tear Off/Bin (Set)
U
and Load/Eject
D
U