Epson PowerLite 7850pNL Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perangkat lunak Epson PowerLite 7850pNL. Epson PowerLite 7850pNL 12 halaman. Release of emp ns connection for windows & mac upgrade from v2.50 to v2.51
Juga untuk Epson PowerLite 7850pNL: Panduan Pengguna (42 halaman), Panduan Pengoperasian (36 halaman), Suku Cadang Pengganti (1 halaman), Panduan Pengoperasian (47 halaman), Pengaturan Cepat (2 halaman), Brosur & Spesifikasi (2 halaman), Panduan Informasi Produk (25 halaman), Buletin Dukungan Produk (25 halaman), Buletin Dukungan Produk (38 halaman)

Halaman Cetak

Epson PowerLite 7850pNL Panduan Pengguna

Make sure AirPort is turned on. Click the AirPort icon on the

■

Application bar and select

see the AirPort icon, follow the instructions beginning on page 5

to enable AirPort.

If possible, move your projector, Macintosh, and base station (if

■

you're using one) closer together.

If you're using Access Point (infrastructure) mode and you're

■

connecting to the wrong network, you may be experiencing signal

interference from another network. Open the

folder on your hard drive, then double-click the

Double-click

AirPort Admin Utility

station listed, reset the base station (see the instructions that came

with your base station).

If your base station is listed, check its name and IP address. Your

projector should have the same ESSID name, and the first three

segments of the projector's IP address should be identical to the

first three segments of the base station's IP address. The last

segment of the projector's IP address should be close, but not

identical to the last segment of the base station's IP address. In

addition, the projector's gateway address should be identical to

the base station's IP address. See the User's Guide for instructions

on setting up the projector in Access Point mode.

If you're unable to connect to the projector, use IP Connect

■

Mode to connect manually. See the User's Guide for instructions.

Check the Network Configuration tab for your AirPort base

■

station. If you set up your projector to connect in DHCP mode,

Distribute IP Addresses

both be on. See your AirPort documentation for details about

configuring your base station.

if necessary. If you don't

AirPort: On

Applications

Utilities

. If you don't see your base

and

Start a Single IP Address

folder.

note

In Access Point mode, your

projector's ESSID name and

IP number are shown at the

bottom of the EasyMP

Network Screen.

should