Epson PowerLite 8300i with EasyMP.net module Pengaturan Cepat

Jelajahi secara online atau unduh pdf Pengaturan Cepat untuk Perangkat lunak Epson PowerLite 8300i with EasyMP.net module. Epson PowerLite 8300i with EasyMP.net module 2 halaman. Release of check tool for network projectors v1.00 for windows
Juga untuk Epson PowerLite 8300i with EasyMP.net module: Panduan Pengguna (42 halaman), Panduan Pengoperasian (36 halaman), Panduan Pengoperasian (47 halaman), Buletin Dukungan Produk (27 halaman), Panduan Cepat (20 halaman), Daftar Bagian (1 halaman), Panduan Tambahan (2 halaman), Brosur & Spesifikasi (2 halaman), Panduan Pengguna (1 halaman), Buletin Dukungan Produk (25 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (41 halaman), Buletin Dukungan Produk (34 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (15 halaman), Buletin Dukungan Produk (22 halaman), Pengaturan Cepat (2 halaman)

Halaman Cetak
Epson PowerLite 8300i with EasyMP.net module Pengaturan Cepat
C
onnect the projector
to your laptop
1
Locate the required cables:
2
Connect the computer cable to the
Computer 1 port on the projector.
3
Connect the other end to your laptop's video-out
or
monitor port.
4
Plug in the power cord.
T
urn on your equipment
1
Turn on your laptop.
2
Remove the projector's lens cover.
3
Make sure the
power light
is orange and not flashing.
Power button
4
Press the
Power button to turn on the projector.
CAUTION: Before unplugging the projector...
To shut down the projector properly
1. Press the
Power button twice. Let the projector cool while
the power light flashes orange (about 45 seconds).
2. Once the light stops flashing and stays on, it's safe to unplug
the projector.
Never unplug the projector when the
flashing orange.
Power cord
Computer cable
Make sure power light
is not flashing
power light is green or
EPSON
Follow these instructions to connect the projector to your
laptop. For other setup options, see your User's Guide.
A
djust the image
1
If you've turned on your laptop and you don't see an image, press
the Computer/DVI button on the projector to select Computer 1
as the image source.
NOTE:
If you still see a blank screen or have other difficulties,
see the troubleshooting tips on the back of this sheet.
2
Adjust the sharpness, size, and height of the image:
Focus
to sharpen
the image
3
If your image looks like
one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
4
If your image looks like
square up the image.
Turn over
®
PowerLite
®
8300i

Quick Setup

Zoom
Lens Shift
to enlarge
to adjust the
the image
image height
or
, you've placed the projector off to
or
, use the Keystone button to