Epson Stylus Pro 10000 Series Panduan Perakitan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Perangkat lunak Epson Stylus Pro 10000 Series. Epson Stylus Pro 10000 Series 12 halaman. Auto take-up reel unit
Juga untuk Epson Stylus Pro 10000 Series: Spesifikasi (6 halaman), Informasi Produk (16 halaman), Panduan Instalasi (26 halaman), Panduan Instalasi Cepat (34 halaman), Panduan Referensi Cepat (12 halaman), Garansi (28 halaman), Panduan Referensi Cepat (12 halaman), Spesifikasi (4 halaman), Spesifikasi (1 halaman), Panduan Pengguna (13 halaman)

7. Hook the both ends of the center shafts (I) on

the upper basket hooks.

8. Hold the front side shafts (J) and turn it one

revolution as shown below.

9. Slide out the lower basket hooks to their full

length, then attach the L shape ends to the joint

sockets (K) on the front side.

10. Slide the upper and lower basket hooks back.

11. Hook the basket rings in the direction shown

below to take up the slack.

Connecting the power cord

1. Connect the power cord to the AC inlet on the

back of the printer.

2. Attach the three clamps packed with your

printer, then route the power cord through the

clamps at the rear of the printer.

3. Check the label on the back of the printer to

make sure the voltage required by the printer

matches that of the electrical outlet you are

using.

4. Plug the power cord into a properly grounded

electrical outlet.

If you need to transport your printer a long

distance, the printer should be repacked using the

original boxes and packing materials. Contact

your dealer for assistance.

Caution:

Do not use an outlet that is controlled by an

automatic timer or wall switch. Otherwise,

accidental shut down or damage to your

printer may occur.