Epson Stylus Pro 4800 Portrait Edition Setup Manual - Halaman 5

Jelajahi secara online atau unduh pdf Setup Manual untuk Perangkat lunak Epson Stylus Pro 4800 Portrait Edition. Epson Stylus Pro 4800 Portrait Edition 15 halaman. Stylus pro 800 series
Juga untuk Epson Stylus Pro 4800 Portrait Edition: Brosur & Spesifikasi (8 halaman), Panduan Memulai (10 halaman), Manual (17 halaman), Informasi Penting (2 halaman), Panduan Referensi Cepat (12 halaman), Garansi Terbatas (12 halaman), Brosur & Spesifikasi (6 halaman), Panduan Instalasi (4 halaman), Brosur & Spesifikasi (16 halaman)

Removing the protective materials

To prevent damage during shipping, your printer

is packed with several pieces of protective

material. Remove the protective material from

your printer before using it. Open the top cover,

loosen the two screws, and then pull out the

carriage fixed board.

You also need to unlock the print head, by pulling

the green tab on the left side of the print head.

Setting Up the Printer

Connecting the power cord

1. Check the label on the back of the printer to

make sure the voltage required by the printer

matches that of the wall outlet. Also, make

sure that you have the correct power cord for

your power source.

Caution:

It is not possible to change the printer's

voltage. If the rated voltage and your outlet

voltage do not match, do not plug in the

power cord, and contact your dealer for

assistance.

2. Connect the power cord to the AC inlet on the

back of the printer.

3. Plug the power cord into a properly grounded

wall outlet.

Caution:

Do not use an outlet that is controlled by an

automatic timer or a wall switch; otherwise,

accidental shut down or damage to your

printer may occur.

Installing the paper tray

Insert the paper tray in the slots at the front of the

printer.

AC inlet