Toshiba E-Studio 5506AC Panduan Persiapan Kertas - Halaman 24

Jelajahi secara online atau unduh pdf Panduan Persiapan Kertas untuk Semua dalam Satu Printer Toshiba E-Studio 5506AC. Toshiba E-Studio 5506AC 46 halaman.

Halaman Cetak

1.LOADING PAPER

 Standard size paper on the bypass tray

 Automatic 2-sided printing cannot be applied to some kind of paper in the bypass tray. For the paper which

Automatic 2-sided printing cannot be applied to, refer to the Specifications Guide.

 For OHP films (Transparency), only 1-sided printing can be performed.

 If paper cannot be fed, printing takes a long time after feeding or the quality is poor, turn over the paper and place

it again or place fewer sheets.

Place paper with its print side down on the bypass tray.

Hold the knob and align the side guides to the paper length.

When paper is placed, the menu for bypass tray settings appears.

There is no affect on the printing quality though noise may occur during paper feeding depending on the paper

type.

Check that there is no gap between the paper and the side guides.

If the gap is too wide, it could cause paper misfeeding, or the paper size could not be correctly detected.

Between the paper and side guides ("A" in the figure):

Make sure there is no gap. (0.5 mm (0.02") or less on one side, 1.0 mm (0.04") or less in total) However, if paper

misfeeding occurs, make a gap.

24 Loading Paper on the Bypass Tray