Philips AZ 1004/00C Panduan Servis - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Servis untuk Sistem stereo Philips AZ 1004/00C. Philips AZ 1004/00C 24 halaman. Cd stereo radio recorder
![Philips AZ 1004/00C Panduan Servis](/uploads/products/server2/6303487/6303487.jpg)
CONNECTIONS AND CONTROLS
Power Supply
Whenever convenient, use the mains supply cord if you want to
conserve battery life. Make sure you remove the plug from the
set and wall outlet before inserting batteries.
Batteries (not included)
1 Open the battery compartment and insert six batteries, type R-
14, UM-2 or C-cells, (preferably alkaline) with the correct
polarity as indicated by the "+" and "–" symbols inside the
compartment. (See 1)
2 Replace the compartment door, making sure the batteries are
firmly and correctly in place. The set is now ready to operate.
Batteries contain chemical substances, so they should be
disposed of properly.
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to burst:
• Do not mix battery types: e.g. alkaline with carbon zinc. Only use
batteries of the same type for the set.
• When inserting new batteries, do not try to mix old batteries
with the new ones.
• Remove the batteries if the set is not to be used for a long time.
Using AC Mains
1 Check if the power/mains voltage, as shown on the type
plate located on the
bottom of the set, corresponds to your local power supply. If
it does not, consult your dealer or service center.
2 Connect the power cord to the AC POWER/MAINS inlet and
the wall socket. The mains lead is now connected and ready for
use.
3 To switch the set off completely, withdraw the power cord from
the wall socket.
• Disconnect the mains lead from the wall socket to protect your
set during heavy
thunderstorms.
The type plate is located on the bottom of the set.
Switching POWER on/off:
Save energy
To avoid unnecessary energy consumption, always adjust the
source selector to TAPE/
Also check that the tape deck keys are released.
For more information on operation instruction please visit Philips Audio internet site :
http://www.audio.philips.com
after using the set.
POWER OFF
General operation
1 To select your sound source adjust the source selector to :
CD, TUNER or TAPE/
POWER OFF
2 Adjust the sound with the VOLUME control.
3 To switch off the set, adjust the source
selector to TAPE/
POWER OFF
keys are released.
Trouble shooting
Problem
– Possible cause
• Remedy
No sound /power
– Volume not adjusted
• Adjust the VOLUME
– Power cord not securely connected
• Connect the AC power cord properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Display does not function properly/ No reaction to
operation of any of the controls
– Electrostatic discharge
• Switch off and unplug the set. Reconnect after a few seconds
The CD skips tracks
– CD damaged or dirty
• Replace or clean CD
– Program is active
• Quit program mode
-- indication
– No CD inserted
• Insert a CD
– CD badly scratched or dirty
• Replace/ clean CD, see Maintenance
– Laser lens steamed up
• Wait until lens has cleared
– CD-R is blank or not finalized/ CD-RW inserted
• Use a finalized CD-R or suitable CD Audio disc only
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts, see Maintenance
– Use of incompatible cassette types (METAL or CHROME)
• Only use NORMAL (IEC I) for recording
Recording does not work
– Cassette tab(s) may be broken
• Apply adhesive tape over the missing tab space
.
position and check the cassette