Philips AZ102N Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem stereo Philips AZ102N. Philips AZ102N 13 halaman. Cd soundmachine
Juga untuk Philips AZ102N: Panduan Pengguna (15 halaman), Spesifikasi (2 halaman), Panduan Pengguna (14 halaman), Panduan Pengguna (2 halaman), Panduan Pengguna (2 halaman), Panduan Pengguna (2 halaman), Panduan Pengguna (18 halaman), Panduan Pengguna (1 halaman), Panduan Servis (11 halaman)

Philips AZ102N Panduan Pengguna
Maintenance & Safety ( See 8 )

CD player and CD handling

If the CD player cannot read CDs correctly,
use a cleaning CD to clean the lens before
taking the set to repair.
The lens of the CD player should never be
touched!
Sudden changes in the surrounding
temperature can cause condensation on the
lens of your CD player. Playing a CD is then
not possible. Do not attempt to clean the
lens but leave the set in a warm environment
until the moisture evaporates.
Always close the CD door to avoid dust on
the lens.
To clean the CD, wipe in a straight line from
the center towards the edge using a soft,
lint-free cloth. Do not use cleaning agents as
they may damage the disc.
Never write on a CD or attach any stickers
to it.

Safety information

Place the set on a flat, hard and stable
surface so that the system does not tilt.
Where the MAINS plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
The apparatus shall not be exposed to
dripping or splashing.
Adequate ventilation with a minimum gap
of 15cm (6 inches) between the ventilation
holes and surrounding surfaces is necessary
to prevent heat build-up.
Do not cover the ventilation openings with
items such as newspapers, table-cloths,
curtains, etc.
No objects filled with liquids, such as vases,
shall be placed on the apparatus.
No naked flame sources, such as lighted
candles, should be placed on the apparatus.
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
To clean the set, use a dry cloth. Do not
use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may
harm the housing.