MSI MSI-8000HD Panduan Operator - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Operator untuk Monitor MSI MSI-8000HD. MSI MSI-8000HD 48 halaman. Rf remote display

Halaman Cetak

3.3.1 Manual Total

The

key under the MANUAL TOTAL mode functions in this manner:

Fx-TOTAL

Load is more than 1% of capacity and has not been totaled.

1. Push the

Fx-TOTAL

LED blinks to indicate the load value was accepted.

The TOTAL LCD annunciator and the Total weight is displayed briefly, then the

number of samples.

2. Current load has been totaled, push the

the 1% threshold is exceeded.

If key is pressed prior to the 1% threshold being met it will display the current

Note

total .

3.3.2 Auto Total

The

Fx-TOTAL

key under the AUTO TOTAL mode functions as Auto Total On/ Auto

Total Off.

The Auto Mode has three variations which are programmed in the SETUP menu:

• AutoLoad - Any settled load above the 'Rise above' threshold will be

automatically totaled. Then the scale must fall below the 'Drop below' threshold

before another total is allowed.

• AutoNorm - This mode takes the last settled load to auto total with. The total

occurs only once the Scale goes below the threshold. This allows the load to be

adjusted without a total occurring. Once load is removed, the Scale uses the last

settled reading for total.

• AutoHigh - Similar to the AutoNorm mode except the Scale uses the highest

settled reading. Useful for loads that can't be removed all at once.

3.3.3 View Total

The

Fx-VIEW TOTAL

of samples. While the display is showing the Total, Total is cleared by pressing

3.4 Net/Gross

Switches the display between Net and Gross modes.

Net weight is defined as Gross weight minus a Tare weight.

To switch between Net Mode and Gross Mode press the

the Net/Gross function). The

been established.

Switching back to Gross mode from Net mode will not clear the Tare value. This

allows the operator to use the Gross Mode temporarily without having to reestablish

the tare value. Only clearing or setting a new tare will change the tare value held

before switching into Gross Mode.

MSI-8000HD Operator's Manual

key to add the current load to the TOTAL weight. The

key activates the Total weight display followed by the number

Fx-NetGross

Fx-TOTAL

key to add more weight once

Fx-NetGross

key will only function if a Tare value has

ZERO

key (setup to