Philips DCD1190 Panduan Pengguna - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem stereo Philips DCD1190. Philips DCD1190 29 halaman.
Halaman Cetak
4 Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
•
Risk of decreased battery life! Never mix different
brands or types of batteries.
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert the supplied AAA batteries with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
10
EN
Demonstrate the features
In standby mode, press and hold
seconds to demonstrate features of this device.
» The features are displayed one by one
across the display panel.
• To turn off the demonstration, press
again.
Set clock
1
In standby mode, press and hold CLOCK
SET on the remote control for three
seconds.
» [24H] or [12H] hour format is
displayed.
2
Press
/
to select [24H] or [12H]
hour format, and then
3
Press CLOCK SET to confirm.
» The hour digits are displayed and begin
to blink.
4
Repeat steps 2-3 to set hour and minute.
Note
•
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
•
You can view clock information in power-on mode by
pressing CLOCK SET.
for three