Philips DS9800W/10 Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem stereo Philips DS9800W/10. Philips DS9800W/10 29 halaman. Docking speaker system
Juga untuk Philips DS9800W/10: Panduan Memulai Cepat (2 halaman), Panduan Servis (36 halaman)
Turn DS9800W on
After proper power connection, the unit
switches on automatically.
Wait for successful boot-up of the unit.
» The boot-up takes about 35 seconds.
» During boot-up, the LED indicator
on the back of the unit blinks green
» After boot-up, if no Wi-Fi connection
has been set up for DS9800W, the
LED indicator starts to blink green
slowly.
To switch the unit to standby mode,
press
.
To switch the unit on from standby mode,
press
again.
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat,
1
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
Before you press any function button on the remote
control instead of the main unit.
If you are not going to use the remote control for a
long time, remove the battery.
Point the remote control directly at the IR sensor on
the front of the main speaker for better reception.
EN
11