Toshiba TDP-MT500 Panduan Pemilik - Halaman 36

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Proyektor Toshiba TDP-MT500. Toshiba TDP-MT500 42 halaman. Home projector
Juga untuk Toshiba TDP-MT500: Panduan Pemilik (40 halaman)

Toshiba TDP-MT500 Panduan Pemilik

TROUBLESHOOTING

Before asking for repair of the projector, check the followings: If the problem still continues, stop using
it and be sure to unplug the power plug. Then, contact the delivery agent of the projector.
Picture images are not projected on screen.
Phenomenon
Power can not be turned
on.
Picture images are not
projected on screen.
Projected images sud-
denly disappear.
36
Check/Countermeasure
Check whether the indicators are on or off and how they are lighting.
POWER LAMP TEMP Countermeasure
• Connect the power cable to the projector.
• Plug the power plug into a power outlet.
• Turn "On" the main power switch.
Off
Off
Off
• Fit the rear lamp cover.
• If the projector itself is very hot, turn off the power switch, and
after the temperature has come down, turn on the power switch again.
• Replace the light-source lamp. (The lamp is at the end of its life.)
On in red
Off
On in orange
• If the intake and/or exhaust vent is blocked with anything, remove it.
• Prevent the wind from a heater from blowing into the exhaust
On in
Off
On in red
• Check if the air filter is foul with dust or not.
green
• Press POWER button after POWER indicator has stopped
→ ←
Blinking in
Off
Off
orange
In some cases it takes about one minute to put the lamp on.
On rare occasions, the lamp fails to come on. Then, turn on the lamp again after a few minutes.
If the projector finished operation without sufficient cooling, the cooling fan is turning and the follow-
ing operation of the main power button may not work after the main power was turned on. (At this
time POWER indicator blinks in orange.) After the fan has stopped turning, press the power button
again to turn on the indicator in orange.
Check if the intake vent is not blocked with anything.
Check to be sure that the lamp cover is closed. (See Page 32 and 33.)
Check if the cable connecting the projector and external equipment is not broken.
When an extension cable is used, replace it with the attached cable for checking. If picture images
are normally projected with the attached cable, employ an RGB signal amplifier together with the
extension cable.
This phenomenon may occur if the intake vent and/or exhaust vent is blocked with any-
thing.
(At this time TEMP (temperature) indicator is lighting in red.)
– After removing those things blocking the intake vent and/or exhaust vent, execute the
followings:
1 Wait until the intake/exhaust fan stops turning. (Wait until TEMP (temperature) indica-
tor comes off.)
2 Turn off the main power switch.
3 Wait about 10 minutes.
4 Turn on the main power switch.
5 Press POWER button.
LAMP indicator lighting in red indicates that the lamp must be replaced. Replace the
light-source lamp to a new one. (See Page 32 and 33.)
vent of the projector, if it is happening.
→Clean the filter, if it is foul.
blinking in orange.
If the main power was turned "Off" while the fan was still turning, the lamp may not be able
to come on next time for about one minute after the main power switch is turned "On" .
For about one minute after the light-source lamp has been put out, it is not possible to put the lamp on again.