Toshiba TDP-MT500 Panduan Pemilik - Halaman 37

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Proyektor Toshiba TDP-MT500. Toshiba TDP-MT500 40 halaman. Home projector
Juga untuk Toshiba TDP-MT500: Panduan Pemilik (42 halaman)

Halaman Cetak
Toshiba TDP-MT500 Panduan Pemilik
Problem
Projected images are
distorted.
Projected images are
dark.
Projected images are
blurred.
White dots are seen in
projected images.
Black dots are seen in
the projected images.
A rainbow-color
brume pattern is seen
on projected images.
Fine streak pattern is
seen on projected
images.
Projected images are
wavy.
Tint of projected
images is irregular.
Others
Problem
Hot air comes out of
the exhaust vent.
Menu setting is
disabled.
Abnormal sounds
occur.
If the following problem occurs after the lamp has been replaced, check the following first:
Problem
Power can not be
turned on.
Solution
•
Adjust the projector and the screen so that they are perpendicular to each other. (See
Page 15.)
•
Adjust BRIGHTNESS and CONTRAST in the PICTURE menu. (See Page 29.)
•
Replace the lamp to a new one. (See Pages 34 and 35.)
•
Adjust the focus. (See Page 19 and 23.)
•
Check if the lens cap is on.
•
Clean the lens.
•
Adjust FREQUENCY and PHASE in the RGB & COMPONENT menu. (See Page 28.)
•
Adjust BRIGHTNESS and CONTRAST in the picture quality menu. (See Page 29.)
•
Adjust the projector and the screen so that they are perpendicular to each other.
(See Page 15.)
•
This phenomenon is normal for a DLP projector and is not a malfunction. (A very
small number of pixels may be constantly lighting on or off, but this is not a malfunc-
tion. Pixels of more than 99.99% are acceptable.)
•
This pattern is a color breaking noise that occurs in a DLP system . This is not a
malfunction.
•
This problem occurs due to an interference with the screen surface, and is not a
malfunction. Try to replace the screen or refocus the lens a little.
•
Securely plug the cable connecting the external equipment to the bottom.
•
Keep the projector away from equipment generating interfering radio waves.
•
Check if the cable connecting the external equipment is broken.
Solution
• This air comes out after cooling the inside of the projector. It may feel hot, but is not
a malfunction.
• If POWER can not be turned off, turn off the main power switch and leave the
projector to cool for more than 10 minutes. Then, turn on POWER again.
• On rare occasions, a metallic clank occurs because the color wheel is rotating at a
high speed. This is not a malfunction.
Solution
•
Securely fit the lamp cover. (See Pages 34 and 35.)
•
Reset the lamp-used-hours. (See Page 35.)
TROUBLESHOOTING
37