Toshiba TDP-S80 Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Proyektor Toshiba TDP-S80. Toshiba TDP-S80 25 halaman. Svga / with document camera
Juga untuk Toshiba TDP-S80: Panduan Pemilik (25 halaman)

Halaman Cetak

Names of each part on the document camera

(1)

(2)

(3)

(4)

Name

: Function

(1) Tray

: The document camera is mounted.

(2) Lock switch

: Used when the document camera is attached/detached

to/from the tray.

(3) Lock lever

: Locks the document camera onto the tray.

(4) Camera output terminal

: Used connect the supplied document camera cable to

(CAMERA OUT)

the COMPUTER IN (camera) terminal of the projector.

(5) Tip resistant bar

: Pulled out when a camera is used separated from the

projector.

(6) Camera arm

: Adjusts the shooting angle.

(7) Lock lever

: Used when the document camera is detached from the

tray.

(8) CAMERA button

: Toggles between the camera input and previous input.

p.36

(9) CAMERA GAIN buttons

: Adjusts the camera gain.

(10) Focusing lever

: Adjusts the focus.

(11) Camera lens

: Shooting lens for the document camera.

(12) Camera head

: Document camera.

(TDP-S81)

(12)

(8) (9)

(6)

(5)

(7)

p.36

Preparing and using the remote control

Loading dry-cell batteries

into the remote control

q Remove the battery cover.

(11)

(10)

w Insert the dry-cell batteries.

Be sure to align the plus and minus

ends of the batteries properly.

Two batteries (R6, SIZE AA) are used.

e Replace the battery cover.

Dry-cell batteries

• Before using the batteries, be sure to observe the Safety Precautions described in

previous pages.

• Remove batteries from remote control when not using for extended periods.

• If the remote control stops working, or if its range decreases, replace all the batteries with

new ones.

The remote control

• The remote control may fail to operate if the infrared remote sensor is exposed to bright

sunlight or fluorescent lighting.

• Do not drop or bang.

• Do not leave in hot or humid locations.

• Do not get wet or place on top of wet objects.

• Do not take apart.

• In rare cases, ambient conditions could impede the operation of the remote control. If this

happens, point the remote control at the main unit again, and repeat the operation.

Operating the remote

control

Point the remote control toward the

projector's infrared remote sensor,

and press a button on the remote

control.

• Operating the projector from the front

Approx. 15°

• Operating the projector from the rear

Approx. 15°