Toshiba TDP-T350 - XGA DLP Projector Panduan Pemilik - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Proyektor Toshiba TDP-T350 - XGA DLP Projector. Toshiba TDP-T350 - XGA DLP Projector 31 halaman. Tdp-t250u user's guide
Halaman Cetak
Operations
Turning the power on and off
■ Connecting the power cord
1
Insert the power cord connector into
the AC IN socket of the projector.
2
Insert the power cord plug into a
wall or other power outlet.
■ Removing the lens cover
Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.
■ Turning the power on
1
Turn on the main power
switch
The ON/STANDBY indicator will
change to orange, indicating standby
mode.
2
Press the ON/STANDBY
button.
The power turns on with a beep sound,
and the following 3 green indicators
light: ON/STANDBY, LAMP, and FAN.
After a moment, the start-up screen
appears.
CAUTION
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes or sight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could cause
burns, deform/break the object.
Power cord connector
(Supplied)
Remote
Control panel
Control
Start-up screen
26
Notes
• The start-up screen will disappear after a moment. You can dismiss the start-up screen
before this by performing any operation. You can also configure the start-up screen not to
appear via the Display setting menu
• The first time you use the projector after purchase, after the start-up screen disappears,
the start menu is displayed
.
p.28
• You can disable the beep sound in the Default setting menu
■ Turning the power off
1
Press the ON/STANDBY button.
A message appears on the screen, confirming that you wish to shut off the power. This
message will disappear after a moment. (This operation is no longer valid after the
message disappears.)
2
Press the ON/STANDBY button again.
A beep sound is made and the screen turns off, but the internal cooling fan continues
to operate for a short while. Then, the projector goes into standby mode.
When cooling lamp
During internal cooling
A
B
During cooling, the LAMP indicator flashes. In this state, the power cannot be
A
turned back on.
If you are in a hurry, there is no problem with unplugging the power cord or
turning off the main power switch in this state.
After the LAMP indicator goes off, the FAN indicator keeps lighted and the
B
cooling fan continues to operate for a short while, in order to expel excess
internal heat.
In standby mode
C
Note
• The projector consumes about 16W of power in standby. We recommend that you unplug
the power cord or turn off the main power switch if you will not be using the projector for
an extended period.
PRECAUTION
• If the power cord is unplugged before cooling is complete, give the lamp time (about 5
minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light, and
its lifetime will be shortened.
.
p.40
p.42
.
After cooling complete
C
27