Philips FW P880 Panduan Pengguna - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem stereo Philips FW P880. Philips FW P880 32 halaman. Mini hi-fi system with 3cd changer, 400 watts total power, 5 speaker dolby pro-logic system and woox technology
Juga untuk Philips FW P880: Spesifikasi (2 halaman)
Halaman Cetak
To change the playback side on tape
deck 2 only
G Press í or ë.
➜ The A (BACK) or B (FRONT) will appear
on the display, depending on the tape side
selected.
To change the playback mode on tape
deck 2 only
G Press AUTO REVERSE repeatedly to select
the different playback modes.
å
: playback on one side of the tape only.
∂ : both sides are played once.
∫ : both sides are played repeatedly, up
to 10 times each side unless you pressÇ.
To rewind or fast forward during
playback
G Press and hold à or á until the desired
passage is reached, then release.
➜ The tape continues playing.
G The tape will stop automatically at the end of the
rewinding or fast forwarding.
➜ During searching, the sound is reduced to a
low volume.
To rewind or fast forward when playback
is stopped
1
Press à or á.
2
Press Ç when you reached the desired passage.
Note:
– During rewinding or fast forwarding of a tape, it
is also possible to select another source (CD,
TUNER or AUX, for example).
pg 001-032/P880/37-Eng
Tape Operation/Recording
General Information on
Recording
G For recording, use only tape of IEC type I
(normal tape) or IEC type II (Cr0
G The recording level is set automatically,
regardless of the position of the Volume, VEC,
DSC and so forth.
G The tape is secured at both ends with leader
tape. At the beginning and end of the tape,
nothing will be recorded for six to seven
seconds.
G To prevent accidental recording, break out the
tab on the left shoulder of the tape side you
want to protect.
G If "CHECK TAPE" is displayed, the protection
tab has been broken. Put a piece of clear
adhesive tape over the opening. Do not cover
the Cr0
tab opening.
IMPORTANT!
– Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
– Recording is possible only on tape deck 2.
– Switch off Dolby Pro Logic when
recording.
Preparation for Recording
1
Press TAPE (TAPE 1•2) to select TAPE 2.
2
Load a recordable tape into tape deck 2.
3
Press í or ë to select the recording tape side.
➜ A appears on the display for the reverse
side.
➜ B appears on the display for the forward
side.
25
).
2
tape detection hole when covering the
2
3139 115 20421
12/8/00, 1:54 PM
25