Toshiba TLP-S10 Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Proyektor Toshiba TLP-S10. Toshiba TLP-S10 22 halaman. 1,200 ansi-lumens 2.1 kg eco mode
Juga untuk Toshiba TLP-S10: Panduan Pemilik (22 halaman), Spesifikasi (2 halaman), Panduan Servis (33 halaman)

Halaman Cetak
Toshiba TLP-S10 Panduan Pemilik

Placement

Placement Styles
As shown in the figures below, this device can be placed in 4 different styles.
The factory setting is "floor-mounted front projection." Set the placement style in the
default setting menu
p.30
, in accordance with your needs.
Floor-mounted front
Floor-mounted rear
projection
projection
AC IN
CAUTION
• Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing
the unit.
• If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so.
Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and
specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.
• If the projector is ceiling-mounted, install the breaker for turning off the power in case of
anomaly. Let everyone involved with the use of the projector know that.fact.
Projection Distance and Screen Size
Use the figures, tables, and formulas below to determine the screen size and projection
distance. (Screen sizes are approximate values for full-size picture with no keystone adjust-
ment)
As seen from above
Screen
90°
As seen from the side
Lens center
90°
a
a is the distance (m) between the lens and
the screen, and corresponds to a range of
1.52 m to 11.59 m.
Ceiling-mounted front
Ceiling-mounted rear
projection
projection
projection size (inches) – 0.8668
a =
25.81
screen size
projection distance a (m)
(cm)
40 (102)
1.52
60 (152)
2.29
80 (203)
3.07
100 (254)
3.84
150 (381)
5.78
200 (508)
7.72
250 (635)
9.65
300 (762)
11.59
18

Connection

Before connection
• Read the owner's manual of the device to connect to the projector.
• Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
IN
AC
CRT monitor, etc.
Audio cable
(for computer)
(supplied)
AUDIO
MONITOR
Monitor cable
Mini D-sub 15P-BNC
(not supplied)
To Y/C
B
Green (Y)
Blue (C
Red (C
R
Conversion
To audio
adapter
output
BNC-pin
White (L)
(not supplied)
Red (R)
DVD player
Note
• The AUDIO terminal can be used with all the devices for input terminal.
p.38
, etc.
To audio output
To RGB
output
COMPUTER-
VIDEO
( Y/P
)
VIDEO
S-VIDEO
B
/P
R
CONTROL
Audio cable
(supplied)
S-Video cable
/C
output
R
(not supplied)
),
B
Video cable
)
Yellow
(supplied)
(to video output)
To audio
output
White (L)
To S-Video
Red (R)
output
VCR
Computer (for control)
19
Computer
RGB cable
(supplied)
Control cable
p.40
To RS-232C terminal