MSI E7210 Master-FARM Panduan Pengguna - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Papan Server MSI E7210 Master-FARM. MSI E7210 Master-FARM 34 halaman. (v1.x) atx server board

Halaman Cetak

MS-9149 ATX Server Board

Enable/Disable 82541 GI LAN Jumper: J1

The LAN controller integrated on the motherboard varies depending on

the model you have purchased . Th e default factory set tings are properly

configured for optimal system performance and thus should be left unchanged.

Enable LAN IDSEL

(default)

Cle ar CMOS Jumper: JBAT1

There is a CMOS RAM on board that has a power supply from external

battery to keep the data of system configuration. With the CMOS RAM, the

system can automatically boot OS every time it is turned on. If you want to

clear the system configuration, use the JBAT1 (Clear CMOS Jumper ) to clear

data. Follow the instructions below to clear the data:

JBAT1

Keep Data

MSI Reminds You...

You can clear CMOS by shorting 2-3 pin while the system is off.

Then return to 1-2 pin position. Avoid clearing the CMOS while

the system is on; it will damage the mainboard.

2-18

Disable LAN IDSEL

Clear Data

System Configure Jumper: J3

The J3 jumper det ermines which mode the system will enter while pow-

ered on. During Normal Mode, the system will enter the assigned OS as usual.

During Configure Mode, the system will directly enter BIOS setup utility. This

enables you to modify the BIOS configurations. During Recovery Mode, you

have to insert certain boot disk into t he floppy drive before po wering on the

system. After powered on, the system will read the boot disk and enter DOS.

This enables you to update the BIOS with a Flash utility if necessary.

Normal Mode

The motherboard provides two PCI-X 64bit/66MHz and three PCI 32bit/

33MHz slots.

PCI Slots

Five PCI s lot s allow you to insert the expansion cards to meet yo ur

needs. When adding or removing expansion cards, make sure that you unplug

the power supply first. Meanwhile, read the documentation for the expansion

card to make any necessary h ardware or software settings for the expansion

card, such as jumpers, s witches o r BIOS co nfiguration. Three PCI slot s are

convent ional 32-bit PCI bus slot s and the ot her two are 64-bit PCI bu s (also

called PCIX) slots.

32-bit PCI bus: The bus has 32 data lines and runs at 33MHz.

64-bit PCI bus: The bus has 64 data lines and runs at 33, 66MHz. With

twice data lines and much faster PCI clock, the 64-bit PCI bus increases

the throughput and overall system performance.

Hardware Setup

Configure Mode

Recovery Mode

2-19