3Com 7250 Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel 3Com 7250. 3Com 7250 9 halaman. Converting to managed access point operation
Juga untuk 3Com 7250: Lembar data (4 halaman), Manual Konversi (10 halaman)

Halaman Cetak

Before You Start

Make sure that you have the following items ready for the installation:

3Com Access Point 7250

Standard detachable antennas

Power supply

Power cord

3Com installation CD

Ethernet category 5 straight cables (8-wire)

For wall-mount installations you will need the following items:

Mounting plate

Mounting screws

Plastic anchors for drywall mounting

To use the Web configuration management system, you need a computer running one of the

following operating systems and one of the following browsers:

Operating Systems: Windows 98, Windows ME, Windows NT 4.0 (with the latest

service pack), Windows 2000, or Windows XP.

Browsers: Internet Explorer 5.0 or later. (Internet Explorer 5.5 is available on the

installation CD.)

Prepare for Installation

It is advisable to connect the power and check the Ethernet cables and LEDs before installing the unit in a hard-

to-reach location.

Observe the following power requirements:

The access point complies with the IEEE 802.3af power-over-Ethernet standard. It receives

power over category 5 straight cable. Installation requires the use of either the 3Com power

supply provided or IEEE 802.3af compliant power supply equipment (output power rated

48 V DC @ 350 mA maximum). Such equipment must be safety certified according to UL,

CSA, IEC or other applicable national or international safety requirements for the country of

use. All references to the power supply refer to equipment that meets these requirements.

Because the power supply plug is the only means of disconnecting the access point from

power, make sure the power outlet is accessible.

The power supply can be located indoors at any point between the access point and the LAN

access port where an accessible power outlet exists.

Decide where to place the access point.

Mounted on a wall on a stud (or other hard surface)

Mounted on to drywall

Placed on a flat surface

The location should be elevated and centrally located relative to users on your network. Ceiling mounting is not

recommended.

NOTE: Regulatory restrictions dictate that when the access point is operational a minimum body-

to-antenna distance of 1 meter (3 feet) must be maintained.

Record the access point MAC address and serial number in a safe place before the access

point is installed in a hard-to-reach location. The MAC address is printed on the back of the

access point housing.

Carefully unpack the standard detachable antennas. Screw the antennas on to the SMA

connectors and hand-tighten them. After network startup, you may need to adjust the antennas

to fine-tune coverage in your area.