CRRC MS-BT20 Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Peralatan CRRC MS-BT20. CRRC MS-BT20 17 halaman. For 1/2” meishan bobtail

3. Operation

a. Select the correct nose assembly for the specific fastener to be installed.

(See section 3.2 for the steps of nose installation)

b. Turn the hydraulic system to OFF and disconnect the power supply from unit,

then connect the tool hoses to the tool;

c. Connect the tool's control switch electrical cord to the hydraulic unit.

d. Connect the hydraulic unit to the power supply. Turn on the unit. Press the

tool's trigger a few times to circulate the hydraulic fluid. Observe the action

of the tool and check for any leaks.

e. Check the PULL and PUSH pressure, if necessary, adjust to the proper

pressure.

STEP1: Thread the anvil to the piston.

STEP 2: Thread the jaw into the connecting base through the anvil.

Standard of installed rivet: completely deformed collar and complete pintail.

Qualified

NOT Qualified