CRS 202900 Panduan Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pembersih Udara CRS 202900. CRS 202900 17 halaman. Advanced filter system
Juga untuk CRS 202900: Panduan Pengoperasian (10 halaman)

Halaman Cetak

Connecting the Manifold

NOTE: Do NOT remove the black plastic covers from the check

valves until manifold installation is complete!

1. The manifold block must be connected to the gas lines.

The compression fittings on the block fit 1/8" stainless

steel tubing (202900) or 1/4" stainless steel tubing

(202902). If you need to connect the filter to lines of

another diameter, adapters will need to be installed first.

2. Select the bracket, bench-mount (L-shaped) or wall-

mount (flat), which you intend to use. Use the bracket

first to mark the holes on the bench or wall where the

manifold will be mounted.

The bench-mount bracket can also be attached without

screws by using the supplied double sided tape (see

pictures on page 9).

3.Drill the holes to mount the bracket, either to fit the

anchors provided or to fit the screws without anchors,

depending on the requirements.

• In the case of the Bench Mount II configuration

(see pictures on page 8), the bracket needs to be

screwed into place first, before mounting manifold to

the bracket.

4. If it is not already in position. Insert the long hex-head

screw into the back of the manifold. Fasten one of the

brackets to the manifold.

5. Fasten the bracket to the bench or wall in the correct

position.

CRS AFS Purifier I