CRU WiebeTech Forensic ComboDock Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Stasiun Docking CRU WiebeTech Forensic ComboDock. CRU WiebeTech Forensic ComboDock 6 halaman.

Halaman Cetak

CRU WiebeTech Forensic ComboDock User Manual

SIDE VIEW

DC Power

Connector

1.3 LED BEHAVIOR

LED

COLOR

Power Out

Green

Power In

Green

Write-Block

Green

Error

Red

Drive Access

Amber

HPA/DCO

Green

1.4 WARNINGS AND NOTICES

Please read the following before beginning installation.

General Care

•

The main circuit board of the Forensic ComboDock is sus-

ceptible to static electricity. Proper grounding is strongly

recommended to prevent electrical damage to the enclo-

sure or other connected devices, including the computer

host. Avoid all dramatic movement, tapping on the unit,

and vibration.

•

Avoid placing the hard drives close to magnetic devices,

high voltage devices, or near a heat source. This includes

Protecting Your Digital Assets

SATA Power

Connector

STATE

DESCRIPTION

The Forensic

ComboDock is

Solid

powered on and

outputting power.

The Forensic

Solid

ComboDock is

connected to power.

Write-Blocked mode is

Solid

enabled.

There is a problem

with the Forensic

Solid

ComboDock. Please

contact Technical

Support.

Data is currently being

Solid or

accessed from the

Blinking

attached drive.

A host protected

area (HPA) or device

configuration overlay

Solid

(DCO) has been

detected on the

attached drive.

any place where the product will be subject to direct sun-

light. Do NOT allow water to make contact with the drive

or the Forensic LabDock.

•

Remove the drives before transporting the Forensic

ComboDock to prevent damage to the drive interfaces.

FORENSIC DEVICE USER ADVISORY

Before using this tool for accessing sensitive data, verify the write-

blocking function of the product. Y ou can do so by downloading and

installing the Forensic Software Utility and following the instruc-

tions in its User Manual for performing a write-block test. See Sec-

tion 5 for download and setup instructions.

1 INSTALLATION STEPS

a. Use the provided screws to attach the protective metal plate

to the bottom of your 3.5" hard drive. This step is optional. The

purpose of the bottom plate is to provide protection to the

drive electronics of your hard drive.

b. If you're attaching an IDE/PATA drive, configure the jumpers on

the rear of the drive to Master. Consult the instructions on your

hard drive's label.

c. Connect the Forensic ComboDock to the drive (or adapter),

using the IDE ribbon and the Molex Mini-Fit to legacy power

cable for IDE/PATA drives or the unified SATA data/power cable

for SATA drives.

d. If you're using an adapter, connect the drive to the adapter.

e. Connect the eSATA, FireWire, or USB cable from your computer

to the corresponding port on the Forensic ComboDock.

f. Provide power to the Forensic ComboDock. Connect the

included AC adapter or a SATA power cable from the inside of

your computer case.

g. Turn on the power switch.

h. The "Select Mode" screen will display on the top LCD panel.

Press the Up or Down buttons to select between "write-

blocked" or "read-write" modes and then press Enter. "Write-

blocked" will always be the default mode.

You are now ready to use the Forensic ComboDock to access the

drive. If the hard drive is already formatted, it can be used right

away. If the hard drive is brand new, or its format is not compatible

with your computer, the drive will need to be formatted before