CRU Dataport DE100 IDE Instal Manual

Jelajahi secara online atau unduh pdf Instal Manual untuk Kandang CRU Dataport DE100 IDE. CRU Dataport DE100 IDE 2 halaman. Removable ata 33 drive enclosure

Halaman Cetak

DE100 ATA 33 Install Guide

Removable ATA 33 Drive Enclosure

Cable

Cover

(provided)

Disk Drive

(not included)

Power Cable

I/O Cable

ID Select Cable

Receiving

Frame

Figure 1: Drive Installation Assembly

Receiving Frame Motherboard

Activity Select Jumper (JP39): Default setting is "A" to use the

activity indicator light on the receiving frame. Set to "B" to use the drive

activity light on the computer chassis.

Master/Slave Selection Jumper (J4A): Master Drive configuration

(default). Forces master drive configuration on receiving frame. Change

jumper to set slave drive configuration, or remove jumper to use unit ID

select switch on receiving frame.

Master/Slave Connection (J6): Used for older model drives that do

not support a Slave Present handshake signal at I/O connector Pin-39.

When using two receiving frames, a connection between J6 may be

required.

Remote Drive Activity (J7): Pins A & C are used for remote drive

activity. All other pins are reserved.

Rugged, Reliable, Mobile, Secure

Drive Carrier

#6-32

Phillips Flat Hd.

Screw

(6 total)

Master/Slave Drive Selection

There are two ways to set the Master/Slave drive designation.

1. Use the factory-installed jumper on your IDE drive - In most

cases, the drive will be factory configured as a Master IDE drive

using a jumper plug on the drive itself. No configuration changes

are required. For multiple drive configurations, it is necessary to set

the first IDE drive as Master and the second IDE drive to Slave. This

can be done by changing the jumper on the IDE drive itself (refer to

the drive manufacturer documentation). This method Requires no

additional configuration of the drive carrier circuit board.

2. Use the hard-wire connector J3 on the drive carrier

circuit board - The Master/Slave drive selection can also be set by

the receiving frame using either Jumper 4A located on the rear panel

or by setting the unit ID select switch. These two methods require the

fabrication of a cable (not provided).

1-800-260-9800

Figure 2: Receiving Frame Motherboard (rear view)