Dimplex DS4411 Panduan Servis - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Servis untuk Kompor Dimplex DS4411. Dimplex DS4411 11 halaman. Compact stove
Juga untuk Dimplex DS4411: Panduan Pemilik (13 halaman), Panduan Pemilik (12 halaman), Panduan Pemilik (15 halaman), Panduan Pemecahan Masalah (4 halaman)
Halaman Cetak
- 1. Model Number
- 2. Table of Contents
- 3. Operation
- 4. Maintenance
- 5. Exploded PARTS Diagram
- 6. Wiring Diagram
- 7. Switch REPLACEMENT - UNITS with Thermostat
- 8. Thermostat CONTROL REPLACEMENT
- 9. Switch REPLACEMENT - UNITS Without Thermostat
- 10. Flicker Motor/Flicker ROD REPLACEMENT
- 11. Heater Assembly REPLACEMENT
- 12. Power Cord Replacement
- 13. Troubleshooting Guide
TROUbLEShOOTINg gUIDE
PROBLEM
general
Circuit breaker trips or fuse
blows when unit is turned on
Unit turns on or off by itself
Lights dim in room while the unit
is on
Power cord gets warm
Appearance
Stove does not turn on Manually
Stove does not turn on with
remote
Flame Frozen
Flame not bright or flame not
visible
Log set dim, ember bed not
glowing
Flame Shudder
Light leaking around the log set
10
CAUSE
Short in unit wiring.
Improper circuit current rating
Remote control has a similar frequency
to other remotes in the area.
Radio frequency disturbance from out-
side sources.
Defective Remote Control Receiver
Unit is drawing close to circuit current
rating
Normal Operation
Defective power cord
Improper operation
No incoming power from the electrical
wall socket
Defective 3-Position Switch
Loose wiring
Improper operation
Remote control not initialized to stove
Defective Remote Control
Defective 3-Position Switch
Defective Remote Control Receiver
Defective flicker motor
Loose wiring
Burnt light bulbs
Loose wiring
Defective light harness
Burnt out light bulbs
Defective flicker motor
Log set not positioned properly
SOLUTION
Trace wiring in unit.
Additional appliances may exceed the current rating
of the circuit breaker or fuse. Plug unit into another
outlet or install unit on a dedicated 15 amp circuit.
Replace Remote Control
Replace Remote Control and Receiver. Initialize Re-
mote Control and Receiver.
Replace Remote Control Receiver. Initialize to Re-
mote Control
Move the unit to another outlet or install unit on a dedi-
cated 15 amp circuit
The power cord may get slightly warm to the touch
when the heater is on
Replace power cord if cord gets hot to the touch.
Refer to Operation Section
Check Fuse/Breaker Panel
Replace 3-Position Switch
Check wiring connections
Refer to Operation Section
Initialize the Remote Control
Install new battery into the Remote Control. Reinitial-
ize remote where necessary
Replace Remote Control Receiver
Replace 3-Position Switch
Replace Remote Control Receiver. Initialize to remote
control
Replace flicker motor
Check wiring connections
Replace light bulbs
Check wiring connections
Replace light harness
Replace light bulbs
Replace flicker motor
Check log set for proper fit
www.dimplex.com