Dimplex TDS8515T Panduan Instalasi dan Pengoperasian - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Kompor Dimplex TDS8515T. Dimplex TDS8515T 17 halaman. Purifire electric stove
Halaman Cetak
- 1. Table of Contents
- 2. Operation
- 3. Parts Drawing
- 4. Replacement Parts
- 5. Parts List
- 6. Upper Light Bulb Replacement
- 7. Lower Light Bulb Replacement
- 8. Filter Replacement
- 9. Main On/Off Switch Replacement
- 10. Manual Selection Switch Replacement
- 11. Upper Light On/Off Switch Replacement
- 12. Heater Assembly Replacement
- 13. Circuit Board Replacement
- 14. Flame Motor/Flame Rod Replacement
- 15. Power Cord Replacement
- 16. Thermostat Replacement
TDS8515T
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE THE CIRCUIT BOARD
1. Gently place stove on it's back on a flat surface.
2. Remove the thermostat knob.
3. Remove the heater cover retaining screws located on the bottom of the stove and
lower heater/light assembly onto the floor.
4. Remove the reflector rod and motor assembly by removing the screws on the front
and rear of the heater cover.
5. Disconnect the wiring clips and connections from the circuit board, noting their
original locations.
6. From inside the fireplace, break off the six mounting studs on the circuit board by
grasping with pliers and twisting on the protruding part of the stud, push the
remainder of the studs out through the top panel.
7. NOTE: New mounting studs are supplied with the replacement circuit board.
8. Properly orientate the new circuit board and connect all of the wiring connections
12