CrustBuster 4740 Panduan Pemilik - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Pertanian CrustBuster 4740. CrustBuster 4740 12 halaman.

Halaman Cetak
Fold and Unfold Instructions
F Folding or unfolding of drill should be done on nearly level ground with the tractor transmission
in neutral.
F When drill is plumbed with markers, the manual selector valve located at rear and top of hitch
will have to be shifted from marker to fold system.
F During the fold and unfold operation, be sure to stay clear of pull bar slides located at front top
of hitch.
F Check that all wing carrier cylinder locks are removed.
F Lower wings by rotating wing carrier arms down out of hooks on front of wing frames. Be sure
wing carrier arms are clear of wing frames before unfolding. Unfolding is complete when pull
bar slides are pulled back against stop, and locked in place by automatic locks located at front
top of hitch. When folding, automatic locks will release pull bar slides.
F Be sure wing carrier arms are lowered to clear wing frames when folding.
F When pull bars come together against bumpers, and rollers on wing carrier arms are centered
under guides on wing frames, drill is completely folded. Wings can now be raised.
F Be sure rollers are securely in hooks on wing frames.
F Install cylinder locks on wing carrier lift cylinders.
F Drill is now ready for transport.
PROCEDURES WHEN TRANSPORTING.
Field Operating Checklist
____ Remove ALL transport locks.
____ Inflate tires to recommended air pressure.
____ Lubrication as required.
____ Seed shafts turned manually to check for obstructions and improper chain alignment on drive
sprockets.
____ Correct sprocket selection and slot width for seed type and size.
____ Calibration as required for accuracy.
____ Drill adjusted at hitch for level field operation.
____ Cylinder stop set for proper toolbar rotation (Initial setting recommended - 1").
Both cylinders for each bar are set equally to avoid twisting tool bar.
____ Down pressure set for soil conditions.
____ Acre meter reset.
____ Lower drill while moving forward to avoid plugging openers.
____ Check seed depth and adjust accordingly.
____ Allow no riders.
____ After approximately 10 hours, check tool bar bolts, wheel bolts, presswheel swivel bolts, etc..
Make sure they are tight.
10
USE GOOD JUDGEMENT AND SAFE OPERATING